No video
Programming Baofeng BF888S Radio using CHIRP
Рет қаралды 8,884
11 ай бұрынIn this video I describe the basic process how to use CHIRP to program radio frequencies into the Baofeng BF888S radio.
theoilykrafter...
@shasashu 21 күн бұрын
Thanks Uncle.
@theoilykrafter 19 күн бұрын
You are welcome.
@ThePolishKid 25 күн бұрын
My CHIRP program says that there is "No response from radio" after clicking "OK" to "communicate" with it. Do you mind telling me how can I fix that?
@theoilykrafter 19 күн бұрын
There are a number of things it could be. A bad programming cable, an in correct baud rate on the COM port, an incorrect data bits and stop bit setting. It could also be that you have the wrong model radio selected or a radio that is not supported by Chirp.
@TerrellBrown-dh6dm 8 ай бұрын
Great. Thanks
@theoilykrafter 7 ай бұрын
You are welcome!
@edenc9275 Ай бұрын
This is a great video and exactly to the point, however I'm still unclear why I would be doing this. Is it to make sure that all my BF888s radios share the same frequencies for each channel? And you replaced the settings with an existing file; where did you get that file?
@theoilykrafter Ай бұрын
I used Chirp to create the program that was written to the radio. After programming the first radio. I read from the next radio and copy and pasted the frequency table into the tab that I just read from the radio after saving the original configuration. Then after pasting would save and write to each subsequent radio to ensure that they all have the exact same program.
@yvesseydou964 10 ай бұрын
Thank you; good tutorial
@theoilykrafter 7 ай бұрын
Thank you.
@Meister_J 7 ай бұрын
Thank you, this was great. How would I program the same radio to work with other brands like SFE, Panasonic? I recently had to replace my radio but I'm struggling with the setup
@theoilykrafter 7 ай бұрын
You will either need software to program your radios or become proficient at programming them from the front panel. Here is a link to check and see if your radio is supported by Chirp. chirp.danplanet.com/projects/chirp/wiki/Home
@Meister_J 7 ай бұрын
@theoilykrafter Thank you. My Baofeng 888s is supported but the SFE S780H RADIO is not support. So I can't configure them. I tried contacting SFE
@miguelesteves9740 5 ай бұрын
The software won't allow to change the language like some others do. That would be helpful as well
@theoilykrafter 4 ай бұрын
I am not sure that I understand the question. Are you referring to the language setting in Chirp ?
@LeePyatt 4 ай бұрын
great tutorial. fails for me with no response from radio
@theoilykrafter 4 ай бұрын
Thank you. Sorry to hear that you haven't had success with responses to your attempt.
@LeePyatt 4 ай бұрын
@@theoilykrafter i finally had success. required turning it on counting 2-4 mississippi and hitting the ok button.
NotaRubicon Productions
Рет қаралды 476 М.
Fit to a 'T'
Рет қаралды 32 М.
Prisoners No Longer Accepted
Рет қаралды 17 М.
Ham Radio Crash Course
Рет қаралды 215 М.