I wish the 'factory' instructions were as clear, thank you Gary for clearing up a simple issue I had.
@mightiflier58135 жыл бұрын
Same here!
@SlickD2178 жыл бұрын
love mine. love the center "dial" channels for my nitro heli throttles
@m3sca1 Жыл бұрын
awesome thanks a was doin my brain trying to save and didnt know about long press cancel button to save. 🤓👍
@rudyackerman57474 жыл бұрын
I see you are using this radio for RC tanks. Are these Tamiya tanks. Do you know the set up where switches are used for firing the main and machine guns. Thanks
@DeanF8 жыл бұрын
Thank you! Do you know if you can you bind this with a DRX R615X Receiver?
@garyhoff21788 жыл бұрын
Sorry, don't know. Since I only run one tank on each TX I've never needed more than the RX that comes with the radio.
@DeanF8 жыл бұрын
Thanks for the video though it's been helpful!
@thomassforza89907 жыл бұрын
Gary thanks much for the info. Could you tell me how I can have not only the elevator on the right sick, but also the rudder. I am new to Rc planes so I am not sure this TGY I 6 can do that. Tom
@garyhoff21787 жыл бұрын
Sorry, but I know nothing about planes.
@ryanm.1917 жыл бұрын
Hello, thank you for the detailed instructions. While programming this controller for my quadcopter, I tried to make my second aux channel (6) but it says source used. How can I bind this to SWB?
@garyhoff21787 жыл бұрын
Sorry, don't know. I can barely make it drive a tank, let alone a heli.
@ryanm.1917 жыл бұрын
Gary Hoff haha, it's ok. I managed to fix it. I hacked into the coding and deleted the sixth channel, then made a seventh channel, that imitated the sixth. Thanks for replying though, I've been waiting on months for another person to respond
@eleazarmina72397 жыл бұрын
i use factory reset then , all my sensors are gone. what should i do?
@drestarss6 жыл бұрын
thats the same transmitter as flysky???
@garyhoff21786 жыл бұрын
Yes
@abdaziz11007 жыл бұрын
I ve set from normal to reverse mode n it is well functioning but when i turn on the tx it back to normal. N i ve to set again .it is not saved in the system.
@danielcabas6 жыл бұрын
You need to hold the cancel button until get out of the menu configuration. You will save the changes