Thanks for the comments

Wadayatalkinabeet sassmate

Thanks for the comments

Thanks for the comments

Thanks for the comments

Thanks for the comments

Thanks for the comments, very soon 28 August

You are welcome!

My pleasure!

Thanks for the comments, don'y we all.... txs

Moet wel he

Bedankt en ja dat heb ik bekeken,, is wel wat duurder

@@D3Sshooter klopt ook onnodig voor deze geweldige race auto maar stel je voor je had een ontstekings deksel van een crossmotor dan is dat natuurlijk geweldig slijt niet snel en is dun

@@thomasvisser2983 , inderdaad

Thanks for the comments,very good point... riding hide rods and preload all act together, changing one makes the other move... the problem I have seen is when changing the rods, to adjust the cross weight balance is often making the car hanging in an angle, and that is not the idea

Or tie rod

@@MB-lh5kw , yes but only in the front . Not in the back on this car unless I was to modify the suspension on this set-up

@@MB-lh5kw He apparently doesn't know how to bump steer the rear of a car. That and assuming all car must be 50-50 balanced.

@@rickden8362 adjusting bump steer is relatively easy, but if there is no height adjustment fittings at inner or outer of the a arms there is nothing he can do about it, apart from surgery.

@@Paulman50 True, but what I've seen of this rebuild I don't believe no rear bump steer was accurate. It's why I question his obsession with a 50-50 balance with now rationale.

you could as well, different approahes and ways

@@D3Sshooter thank you

I use Proform scales (800Kg each) and wireless, runs about 1200 euro for a set. Works great KG's and Pounds... If there is one thing that I could say is less ( but not an issue) , is the On -Off switch on the scales ( that is at the bottom side) and you might need to reset the connection with the controller if by mistake you zero=ed the scale. Hence the car needs to be taken of the scale to get to it. Nothing drastic if you follow the right procedure.

@@D3Sshooter thanks, that's helpful!

No , it did not move, the issue was that the exposure on the camera was set to high , so you could nearly see the reflected dots , so had to color them in... Left to Right Side (in total ) is 50 -50, Left to Right per axle is off, and there is not much that I can do. Off course there will be an effect of the Cross Corner adjustment later... So we will see then

I'm not sure about any thing being ''lop sided'', it's just the state of a car that needs to have everything adjusted properly after being reassembled. I'm not sure where he get's the Idea the car MUST be 50-50 weight balance.

Thanks for the comments, let me tr to answer a few of your questions; Factory specs are what we call a baseline set.. Adjustment are typical made on a track by track basis. Some tracks do define the lowest riding height. Others don's. In each case , I do not want to scrape , unless i would fit scrape guards. Do I have a baseline from the factory ? No , I don't and it would be nice to get it , if it exists. Yes , I now what rake is. I have set the riding height equal so no positive rake, As on this car this would have little effect on the down force , Instead I use the wings/spoiler position to create that down force. Of course I understand that positive rake creates a better ground effect. How it will be set , is something to be finally decided after a shake down. Yes pending the suspension system you ca adjust bumpsteer on the rear wheels, that is why I stated that on this car i would need to modify the suspension. For the front wheels , that is easier as there are many approaches like lowering/raising the steering house or placing spacers on the steering rod.... There are so many methods and topics that its hard to civer them all.. Thanks for the questions

You can, although in this car with a 40/60 Front Rear distribution and 350LB springs, the change is minimal. Me 64 kg, that makes max 1mm of difference. And its a mono seater... That would be different if it was a duo seater. But yes you could do that

Just what I said 😅😂😅

@@Paulman50 Awesome 👌