Great video mate. Reminder the garage is for the truck. Not for your wife junkies 😁

I just put these on my 2025 Ram, very happy with them. I like they are close to the body, they protect the rockers from the rocks getting kicked up from the front tires.

Great instructions. And debunking the 10mm and mud flap gaffs.

BEST video with no BS talking!!

Just installed mine yesterday...I like it a lot. My buddy told me to spray the boards with Flex Seal Spray to prevent rust... I'll prolly give that a try.

Thanks for getting right into it, hate people that say. "Whats goin on you tube!"

Sorry! I got the poor boys Rebel and went with the Warlock. Great clip! Lots of very good advise in here. Mine should be in on Thursday and on the truck this weekend.

Parkway Drive intro... subscribed.

Great video. Thanks for posting it. The information and details will help with my DIY installation of OEM steps on my 2021 Ram. (Black)

Looks good, I went with the black hd1 RC , I wanted them tucked in not hanging down.

Looks amazing man. Just picked up the same exact truck two days ago and I’m going to get these. Now you just need to put tints on.

I have a dumb question...I assumed LH was driver side, hope I was correct? Thanks for the video! Tips on torque spec and washers were helpful. I torqued to 35 psi. I set each board on a long blanket just under the bolts on garage floor, then I laid on my back and lifted each one over my head as I slid under the truck further, until board was on my chest. Then I very carefully lifted it up and set the holes onto the bolts. It went much easier than I expected.

I’m from Minnesota too and just got a ram 1500 last night.

I really like these, can't find em anymore though, just the stainless steel tubular ones.

They look great! I installed the same running boards on my trunk a few days ago!

Fantastic video, thanks! Will be installing these tomorrow!

Suggestions for best way to clean the factory paint off of the threads with out damaging the threads ? Thanks.

Nice install, what splash guards are those? Those splash guards fit really nice, and looks great with the new boards.

Great video, Tony. Thanks. I’m very close to buying these but am not too sure about the “composite” material. How are they holding up? Any road rocks or anything scratch them up? What’s your opinion of the matte vs gloss finish?

One more time brother can you tell me which ones these were Ram is well thanks to truck looks beautiful great video

And got A7x playing? You get a sub from me!

Great Video!! I just picked up a '22 Rebel and ordered the Mopar off road aluminum side steps(which it doesn't say but I guess they are cab length) In the description of the steps on the Mopar website it says that they are not compatible with front splash gaurds. Which side steps did you install and are your front splash gaurds molded or rubber? Don't wanna get the wrong splash gaurds and they don't fit with the side steps.

Awesome truck. I just picked up a 21 Big Horn night edition. Was wondering what kind of tires/ wheels you have on yours? They look awesome

Very helpful video - thank you! I just received these boards and somehow the nuts/instructions fell out of the box during shipping. Are those just standard M8 flange nuts I could pick up from the hardware store?

Looks great 👍

Just got a 2021 Big Horn Midnight, these are my favorite running boards and I want them for mine but I just can't swallow $600 for them.

Thanks for the vid. Look like it might be a little easier install with a friend helping

Seeing the rust on those nuts from the old steps. Makes me so glad that I don’t live in Grand Forks anymore. That salt is a under carriage nightmare. Oregon is much nicer to my vehicle.

have you put any spacers behind rims? Stance looks awesome! What are your tire sizes?

I prefer your wheel and tire set up. What is your wheel and tire size and offset?

How are those holding up? I have found that mine are a “bit” slick after the the rain. Amen to idiots with out lights on the the rain or inclement weather!!!

Hey bud, how are the running boards holding up in regards to rust especially the environment where you live?

Good info

I just picked same set off Marketplace but they did not have the nuts. Any idea what nuts I should use? I have seen M8 x 1.25 13mm not sure if thats correct. Also should I get the Mopar ones or are Lowes or Home Depot same thing? I see some are zinc coated at Lowes so not sure if they will rust up. Did you ever add washers as well? Thanks

Just wondering how the water/rain noise splashing the bottom of the new steps is. If it still happens did you do anything to try to fix that ?

The only negative thing of living in the north is the salt

I want to take off my factory steps of my 2022 BTS. And leave off

I ordered mine off of the Mopar website for my 21 bighorn crew cab. I got the ones that go from wheel to wheel but it didn’t come with the middle bracket. Anyone else order them and they came in like this??

Do you still have the mopar running boards? Do you recommend them? Thanks

do those rain guard things on the windows stop the horrible wind buffeting any time you open the winow?

Any idea on the part # for the quad cab ??

Forest lake "flaked' on you eh? ;)

Looks like they were compatible with OEM splash guards ?

Where I can get those running board

Do they have these for the classic body? Whats the part number?

How much ?

How much were these running boards

you bent them on a pile of SNOW and dented it with your FOOT???

What bed cover are you using?

What brand of mud flaps do you have ?

Would these fit a 2022 crew cab ?

Whats your exhaust setup

How much were the oem stock ones?

Where did you purchase these ?

Where do you find them?

Do you think these will bend at 330lbs

6:30 what's a wizzy wheel?

what engine do you have?