Yhank you Sir.🎉

Damn! That really is a nice shooting board! Nice work :)

Nice! Awesome product!

Greetings from the States! I purchased a ramped shooting board and I love it! You have a new design of the shooting board - with an optional donkey's ear. Will that new donkey ear mate with the older design of the ramped shooting board? Again - many thanks for the fine work you do!

Excelente proyecto muy bien desarrollado y mejor ejecutado , gracias por compartir tanta creatividad y conocimientos , un saludo cordial y por supuesto un gran like desde Narón , Galicia ( España) 🤓🤪

Nice

May I ask why in an updated version you shifted side of the ramp a little bit from that element that goes underneath of the main base structure ? Is there any particular reason for that or so ? I see that's there's an small gap between those supporting rails there

Endlich mal jemanden der Fritz und Franz benutzt

Just received the shooting board and using with my Lie Neilson No. 62 low angle jack plane. Excellent design and build quality, perfect results on 90 and 45 as described, exceptional attention to detail. How about a donkey’s-ear attachment for wide board 45 miter?

I'm not doubting the quality of your work, i just have a couple of questions. As far as it being on a slope, does the grain pattern direction cancel out the benefit at all, and isn't it better to have the fence locked in at 90° instead of having to make sure it's at 90 every time you use it and also risk that it moves while you're using it? Just wondering. Thanks

You should do more videos, I can see you have a good eye for detail and are able to use the right descriptive words. Unlike me! Subscribed.

Nice build. You should sell plans and the cnc files.

Do you have a link for those knobs and the bolts you use? I like the look of them.

I recommend squaring to the sole of the plane rather than the edge of the board.

When you trim the 45 degree mitre for say a picture frame, that now means the piece is shorter in length. So do you then go and trim the same amount off each piece?

Can you provide a link to the low the low friction material the plane rides on?

Was für ein traumhaftes Shooting Board. Wo kann man diese Anti-Rutsch Unterlagen als Privatperson erwerben? Viele Grüße

What prevents the plane iron from continually cutting into the edge of the top?

Do you have plans available? I would love to buy one off you but that's out of my price range.

There is no way to connect through your website. Will you be putting more shooting boards up for sale in the near future?

Cannot connect to your website.

Nice board but that is NOT a shearing cut. As long as the plane moves in a line perpendicular to the face of the iron it is not shearing. The ONLY way to get a shearing cut is if the plane moves at an angle to the face of the iron. The force of the cut is still 90 degrees to the iron. What a ramped chute or work support does is use more of the iron. It is simple physics. It is more like,planing the edge of a board , in your vice by going from the front corner to the back corner, pushing the plane in a straight line. In order for it to be a shear cut you have to move the plane slightly sideways to the iron.