Jerry, Thank you for your video. I am sure this information will come in handy when I pull the transmission from my ranger.
@billvanriper827911 ай бұрын
JERRY , thank you so much i have a 2009 ranger xp 700 3500 miles on it one owner bought new when i pulled it apart things came out i thought i had it back right but only have high and low it was pretty clean inside its been hard to get in gear from reverse to high might b some other problem gonna put back today nice video and very well explained AAAAAAAAA+++++++ i dont think i had it in neutral when i put back together
@ted85243 ай бұрын
I have a 04 ranger 500 2x4I rebuilt mine everything looked good put it in my machine I've got low neutral and reverse but my high gear almost seems like the clutch dog is not engaging it clicks but when I spin the clutch backwards it locks into gear
@jerryjones22153 ай бұрын
Yeah, sounds like worn dogs. All the wear is typically on the load side. Thats why it engages when you spin it backwards because that side of the dogs probably still look like new.
@ted85243 ай бұрын
@@jerryjones2215 so you think it's the clutch dog and not the shifting forks
@colincourier5 жыл бұрын
hi great video,i have this problem i bought a ranger 500 its stuck in reverse when i disassembled it had no spring inside would it cause the problem,pleases help colin.
@mikebearden296210 жыл бұрын
Do you have a video on how to get the trans out
@jerryjones22158 жыл бұрын
Sorry, but I don't. I figured that if you were advanced enough to watch this part, you could probably figure out how to remove it.
@jerryjones22153 ай бұрын
Unfortunately not. I figured that if somebody felt confident enough to tackle rebuilding the trans, then removing it "should" be a piece of cake for them.