How to install reverse camera in a 2006-2011 RAV4, running of cable and hookup
Пікірлер: 42
@MrMoises275 жыл бұрын
Thanks for the video, I just installed the same backup camera on my 2010 RAV4 this Memorial weekend, the part that I had a lot of trouble was the connection of the camera to the backup light, there is not much space to work on but I learned few things during this installation and I will be posting a video so you guys can learn just as I did from this video and others. Good luck.
@deejanandersen70915 жыл бұрын
MOISES F IZURIETA hi good video you made very instructive, I think for the reverse light hook up connecting it at the front of the car as shown in my video is much easier than connecting it at the rear of the car, but both ways work perfectly.. thanks again
@MrMoises275 жыл бұрын
@@deejanandersen7091 your welcome and yes I guess both ways will work fine. Now people will have 2 options to choose from. :)
@samartz4 жыл бұрын
Hi Moises, do you have a link to the video how you connected t the front?
@jonathanhazlett88805 жыл бұрын
I would've thought having the camera off-center over the plate would be a problem, but apparently it works. Thanks for the vid!
@zenoandersen23355 жыл бұрын
Jonathan Hazlett hey thanks yes it works, you just can’t see the towbar, so when hooking up trailers it’s not as good as it could be.. so next time I’ll be putting in a different one more in the middle..
@jonathanhazlett88805 жыл бұрын
@@zenoandersen2335 Assuming you are happy with your camera, may I ask what brand/model it is?
@Lordbaccus4 жыл бұрын
Thank you! I ordered the SAME Camera you got = hooking it up tomorrow
@poulzeno79305 жыл бұрын
Thanks I that was a lot easier to do after watching your video%%
@zenoandersen23355 жыл бұрын
your welcome
@stephengoodwin5 жыл бұрын
Thanks for the info
@mikea53194 жыл бұрын
I thought you would have to wire it to the reverse lights?
@tris44482 ай бұрын
What wire puller you are using?
@bryantcarmona20093 жыл бұрын
Since the ID plate is set to the side on 3rd Gen Rav 4s, does the camera work fine for you in terms of how accurate you sense of placement is when backing up?
@taomibaobao3 жыл бұрын
hi. to initialize the back up camera, we need to remove the connection to the battery for a few minutes?
@mohammedabdelkadir36515 жыл бұрын
So wen I connect the reverse camera wires, how it should work with reversing gear? Does it need another job or the camera should work its self.?
@zenoandersen23355 жыл бұрын
Mohammed Abdelkadir.. you should have a reverse trigger wire that connect to the back of your radio.. you can connect this wire to either the reverse lights at the back of the car or as shown in this video and my other video in more detail “reverse trigger wire finding” once you have connected this wire to your stereo it will know when you are in reverse and switch automatically to the camera input.. :)
@garymatthews70435 жыл бұрын
You connect it to the backup light in the rear. Then whenever backup light comes on, its active. Should have instructions for that Peak camera does.
@garymatthews70435 жыл бұрын
I bought a wireless one. Plug into "cigarette" plug. Other connection is to the backup light wire in the taillight
@davidrahman5 жыл бұрын
Do you have a link for that camera? The box in video doesn't seem to have any brand name on it.
@MrMoises275 жыл бұрын
I bought the same camera and there is not brand name on mine neither.
@MrMoises275 жыл бұрын
I bought the same camera there is not model number and the instructions that came with my backup camera shows other kind of cameras and not this one but it shows how to make the connections and believe me the instruction book are not very good. But I can tell you that the connection to the backup light to power up the camera is very difficult to access to, but at the same time it is easier than the front connection. To me it was very easy to connect the backup camera to my radio. Toyota made it difficult for us, but we can still do it, hahaha . Other cars may have more access to the tail lights but the Rav4 is a lot of work. Good luck.
@jovelynluayon19735 жыл бұрын
how much cost? and installation
@markrobinson38845 жыл бұрын
Hey do they have a kit for toyota noah 2008 too?
@whiskyyy22635 жыл бұрын
Hey, I have the same stereo as yours however the camera I got is different it's got the camera that connects to an extension with black and red to go to reverse lights and the other end of the rca to go to the 4 pin connector for the stereo, I used a voltmeter to see the volts on the trigger wire coming off the 4 pin and it reads 6 however the trigger from the camera is 12 and I cant seem to get it to turn on the stereo, any suggestions?
@zenoandersen23355 жыл бұрын
Whiskyyy yes check out my other video “Toyota reverse camera hookup rav4” you’ll need a 6v relay to allow this to work you can pick these up for under $10.. at the end of the video these a circuit diagram.. cheers
@whiskyyy22635 жыл бұрын
@@zenoandersen2335 thanksss!
@mhh3284 жыл бұрын
How do you remove that huge back panel? You said it pops off but how do I pop it off without cracking the whole thing?
@peterhindes563 жыл бұрын
I have the head unit without the screen. Can I upgrade that to get the backup camera?
@chrisdiehl88174 жыл бұрын
What was the harness you got for the back up light
@johnhill25235 жыл бұрын
were dose the 6volt relay come from?
@zenoandersen23355 жыл бұрын
john hill you can buy one from an electronics store, I got mine from jay car.
@zenoandersen23355 жыл бұрын
See my other video, it shows you how to hook the relay up and you get it from jay car
@MrMoises275 жыл бұрын
Why do you need the 6 volts relay?
@dannyd65843 жыл бұрын
the camera lines in screen is not center of the car when reverse.....How could I fix it? Actually look outside the window is different with screen....
@mariocampbell6448 Жыл бұрын
Wonder if it can work for an 03 rav4
@johnhill25235 жыл бұрын
we need to see were the wiring is connected at the rear of the unit ,we have the same kit and rav 4 and we had to order another small rca cable adapter to plug into the unit,we need to see were the wiring comes from at the unit,you left that bit out,? any one can work the rest out.
@deejanandersen70915 жыл бұрын
john hill please see my other video on the wiring including the relay needed
@deejanandersen70915 жыл бұрын
john hill please feel free to contact me again if it’s still unclear.. thanks
@chiragneha17804 жыл бұрын
Reverse camara is not showing
@zenoandersen23354 жыл бұрын
make sure you power up the unit with the camera connected.. it needs to sense the camera during first start up for it to work... if you have already put it all together might be easiest to pull the fuse or disconnect the battery for to seconds. if it still doesn't see the camera you will need to check your wiring and also ensure you have connected the reverse tigger cable.
@garymatthews70435 жыл бұрын
Don't go through all this. 15-20 minutes with a wireless camera. Plug into 12V plug in car, splice wire into backup light in the tail light.