Order the RE50T Shop Press at www.redlinestands.com/catalog/...
Пікірлер: 13
@Edgunsuk7 жыл бұрын
What controls the speed i need one for forging and that is far to slow
@tri-forceblades31234 жыл бұрын
Why didn't you demo the hydraulic system?
@yellowmetaldriver14602 жыл бұрын
Where is this manufactured?
@Sbullakis877 жыл бұрын
what kind of air compressor does this need to run properly??
@HondaCrf450r.16 күн бұрын
At least 7cfm.
@KarasCyborg4 жыл бұрын
I want one with a dual acting hydraulic ram with an up and down joystick. Not some funky push pedal turn knob BS.
@hydraulic-14013 жыл бұрын
Bravo 👏👏👏@designer and manufacturer Instagram 👍
@HondaCrf450r.15 күн бұрын
You help design this press?
@niemdan Жыл бұрын
Any thoughts on gauge not responding?
@RedlineStands Жыл бұрын
"Assuming" the press is making pressure, then surely the gauge must be bad? We have more gauges here www.redlinestands.com/catalog/shop-equipment-c-327/hydraulic-shop-press-c-327_548/shop-press-parts-c-327_548_236/redline-10200-ton-replacement-shop-press-gauge-p-2601
@niemdan Жыл бұрын
Well, I'm going to bleed it out again and try again. I just put it together but it has been in the shipping crate for over a year while my shop was getting built. The cylinder doesn't seem to be fully extending or retracting either. How much oil is adequate? Thank you
@RedlineStands Жыл бұрын
@@niemdan Just fill the pump with oil till it overflows "with the cylinder fully collapsed." #32 hydraulic fluid. It probably just leaked some out from being laid down for a long time.
@niemdan Жыл бұрын
@@RedlineStands I got it fixed last night. I took oil line off of the gauge and there is that inline screw that was left in there. I unscrewed it and took out completely. Everything works perfectly now. Its a good press, glad I bought it.