Shows how to remove and replace the front coil spring. Video would also apply to many Ford models in that timeframe, as many used the same suspension.
Пікірлер: 6
@anthonyswanson79203 ай бұрын
Great video
@bretthusselbaugh11983 ай бұрын
Thanks!
@jeffbruer873514 күн бұрын
Did you have to cut the jack screw/bolt to get that compressor to work? The bolt is bottoming out hitting the spring perch on mine.
@bretthusselbaugh119813 күн бұрын
I did have to run the compressor as high in the spring as I could in order to keep it from bottoming out. I also released the tension from the anti-roll bar (mentioned that in the video) to allow the upper control arm to move down further (which allows the spring to decompress more fully, which allows you to get that compressor higher in the coils).
@jeffbruer873513 күн бұрын
@@bretthusselbaugh1198 good point about the UCA's being in the lowest point. I have the sway bar out of the car. As best as I can judge from your video, that bolt does look a bit shorter. I will give it a go anyway. Thanks for the reply.
@jeffbruer873513 күн бұрын
I'll add this hack for the long bolt spring compressor that I found last night in case others run in to this issue. kzfaq.info/get/bejne/ipx3dKR4mdjIaJ8.htmlsi=QAPGYJM2VquA__HB