Рет қаралды 266
Quickly remove and install the rear door molding applique trim on a Dodge Nitro. This takes less than 5 ⏳ minutes to DIY. Please 👍👍👍 & SUBSCRIBE 🔔 if this helps. Mention in the COMMENTS 💬💬💬 any thoughts. For step by step guide 📋, tools used, and part number, click SHOW MORE 👉👉👉.
These are all the tools 🧰 to complete the job:
👉 Flat Tip Screwdriver amzn.to/3wbHuZd
OR
👉 Pry Bar amzn.to/3eiB9mG
AND
👉 Double Sided Tape Or Glue
You can also use a 👉 C Clamp amzn.to/3dsFcNv
to further help bond the tape/glue for further reinforcement.
Part Number: 55113100AA or 55113100AB or 55113100AC
👉 amzn.to/3FSVH3N
INSTRUCTIONS:
Step 1: REMOVE:
Use a pry bar on the bottom and sides to pop out the trim and open door to move the applique trim to the side to fully remove from vehicle.
Step 2:
Peel rubber window molding over located at the corner of the door.
Step 3:
Use double sided tape or glue on the backside of the applique trim. Optionally:
Use a clamp to really get the applique trim on tight and so the glue or tape bonds to the door.
Step 4: INSTALL
Open door and slide trim from the edge of the door into place.
Step 5:
Tap on the trim from the front to secure the clips to the door.
Step 6:
Adjust the door molding and peel the molding with a flat head screwdriver. Then use your finger to smooth it out
Step 7:
Please LIKE 👍👍👍 AND SUBSCRIBE 🔔 if you found this video and guide helpful.
Mention in the COMMENTS 💬💬💬 what you think about this video.
If you would like to help grow this channel you can get me a cup of coffee ☕ here:
➡️ www.buymeacoffee.com/randomca...
OR
➡️ ko-fi.com/fixcaryourself
OR
➡️ Click the SUPER THANKS button above.
Remember to always keep learning and if you have something that could help someone out then please contribute and make a difference in other peoples lives!
THANKS AND PLEASE 👍 👍 👍 AND 🔔 #FixCarYourself