I just watched this video and went to Amazon to look for it. Then I saw your review. Lol! It was like it was meant to be. I would have gone with the heat gun and razor blades, but not anymore! Thanks!

I recently used one of these to get adhesive off the backside of a car door plastic trim strip that had fallen off and the metal on the door itself. 3M has the best one at $40 but I bought the cheapo for $6 on Amazon. After a little experimentation with drill speed, it cleaned up both surfaces beautifully so I could put on new adhesive tape and reattach the strip. For my purposes, slower drill speed seemed to work better; if I went too fast it sort of melted the adhesive and made a bit of a mess. At slower speed, it just rubbed everything off like a big eraser.

Glad to see “ Easy Street “ is still on the water, Mark has taken great care of it

Respect the ones that know stuff. Thx Mark ~

Great video! NO MORE HEATGUN!🎉

Really interesting; I have a lot of tools but have never seen or heard of those wheels. My first though would be to use heat. A heat gun might be too much for the fiberglass but a blow dryer might be just about right. Thanks for the video.

Practical! That's the stuff I really like!

Great video, thanks Tim!

Excellent and valuable video!

I would have left the blank space in the front and moved the registration numbers up to where the strip was.

Very impressive and that the gel coat did not require any touch up like compound or wetsand (3000 grit). It would be interesting to see it tried on some other boats where the material or age might be different.

On the internet the wheels are identified as “decal removers”. There are several brands and styles.

Tim. Many years ago I had to remove many layers of bottom paint without damaging the gel coat. Someone just slapped layer on layer without removing anything beneath. I haven't seen these since but we used something akin to a flapper sanding wheel but instead of sanding flaps, they had many stiff, almost thick wire metal, or thin rods, fixed with loops so they could move and flex. Spinning they essentially "shattered" the paint so multiple layers would fly off. Impossible to sand in our lifetime (the paper clogs regardless). They do not work well if the paint is a thin layer well adhered. Back to sanding for that. FYI

I used a scrap pice of acrylic to scrape off resin stickers etc off gel coat. Just a sharp edge square or beveled. If you have some acrylic. Otherwise eraser wheel.

Damn, I should have seen this before!

What is the name of the rubber wheel product and where can you buy them?

Be aware that the product link in the referenced video is to Amazon Canada, not the US. I can and is causing problems if you do not live in Canada.

Smart

That's interesting. The wheel looks like it uses friction to heat and then melt the vinyl to strip it. Huh. Clever. Thanks, PS. Far winds

What is the brand name of the rubber wheel?

Info on where to buy these wheels would be greatly appreciated

It looked like a big spinning eraser.

Great info! Thanks! Too bad Mark has such an "upspeak" problem. Makes my crazy lol.

What brand is the wheel?

Thanks for the info. I need to remove some 40 year old pinstripe from my boat. Where can I get the vented wheel? And the plastic razor blades? Also, do you know where to order new pinstripe (my boat is now no longer built in this color scheme)?

xylene solvent. where are chemical resistant gloves and your eye protection. a dampened paper towel wiped across the vinyl stickers and they will peel right off. use clean paper towel with solvent to wipe up the residue. keep using clean paper towels don't use a rag you will spread the adhesive all over the boat. usually no buffing required.

Duh? Why not just use masking tape and paint full length stripes?