you fail to mention you have to raise washer to unclip pump.....

I can't thank these guys enough for posting this. Performed this same repair in an hour and it went flawlessly. I know a few folks here mentioned it's easier if you lay the washer on its side, but if it's on a pedestal and you don't have help to lift it down, this method let's you repair it in place and was just what I needed. Plus there are a lot of electrical components that will get soaked if you're not absolutely sure all the water is out when you tip the machine. If you're doing this repair because of a possible clog, don't forget to check all three legs of the bellows hose...i found a lot of buildup in there because a deteriorating floor mat was washed (don't ask) and if i hadn't removed and flushed it out, the pump would have just immediately clogged again. Thanks again RepairClinic. Saved me a bundle.

I followed this video and was able to repair my washer by replacing the drain pump motor. Thanks for the video. It was very simple to follow. ❤

I use this to , replace the pump in my washer dryer combination. Because they're so cheap. It only lasted a year so I'm back doing it again so here I am reusing the same video and I appreciate it. It worked great for me the first time.

Wow Instead of using the three screw holes at the bottom of the pump LG decided to make you take half the machine apart Great... Fortunately, I was able to remove our pump by tipping the machine on its side (make sure it won't slip) and use a 5/16" ratchet to remove the bolts from underneath it

Thanks so much! Perfect instructions

Thank you that worked. With a different model.

Super detailed ... even I could do the job with this guidance. Thanks!

I have a 2018 model WM4370HKA and my pump assembly didn't have the clip on the bottom that had to be released, thankfully. I have the washer attached to the small under drawer washer unit, so I couldn't tip mine back to release the small white clip. Mine had 3 hex head bolts that had to be removed, similar in the video where they pointed out 2 screws to be removed and then release the white clip on the bottom. I had 3 bolts then the entire assembly with drain pump and recirc pump came out.

Thank you for this great help video saved me a 1k replacing my washer

Crystal clear tutorial. Thank you.

One of d best video

This video walked me through everything I needed and our washer is running great again, thank you!

Great video and helped so much but just a word of advice, be sure to buy OEM parts, I just had to replace my new pump again after only 3 months because I bought a cheap replacement part......don't be cheap when buying the new parts?

This is great. Thank you! I like that it is simple and step by step. I appreciate it. I did though have to raise the washer. My model is a washer/dryer combo though.

Thank you for video it’s really helped me

Why not just lay the washer on its side and remove the bottom panel to access the pump? Seems like a lot less work. Thanks.

What is the purpose of two pumps on this machine? Or is there 2 options for the same component?

Any other options if you don’t have the spring release tool?

This case if ur washer machine just replace w/ new part, in actually maybe we must remove trapped water

Thank you

Nice

I replaced my pump. It still won’t drain. What’s next?

Hi I ordered a drain pump assembly but it only came with one motor on the left side and not the right.

Im6 thanks

why they put free flying znatit ads in this video?!

Good info big dawg