Repairing a Bosch GSH11E Hammer with a rusted up tool holder. Never had one This bad.

Рет қаралды 6,628

10 ай бұрын

This is one of worst cases of neglect iv seen.
This Bosch hammer must have been left in a bucket of water. The tool holder had completed rusted and siezed the striker inside the tool holder.
Normaly these parts just slide apart. Never needed to take a hammer to one before.
#tools #repair #powertools #fix #toolrepair #machine #deandohertygreaser #howto #bosch #gas11e #rusted #rustedsolid #siezed

Пікірлер: 19

@philgallagher1 4 ай бұрын

I appreciate that these machines are expensive, but surely to god yer man must've known a long time ago that there was something going wrong with it. He must've just waited til it stopped hammering and then just left it. Why wouldn't he have brought it in then?!? Still... A remarkable job, Dean. You should be proud of yerself for getting that one going again!

@jurijrebersek6961 10 ай бұрын

A very nicely presented machine failure and a nicely done repair.

@user-cy6yc6tb3t 10 ай бұрын

Yep mine a similar issue not hammering dean. Need you to hopefully have a wee look at it for me. My hitachi one can’t remove the point. Ha. I’m down to the hammer an bolster.

@jlmowens69 8 ай бұрын

Do you have any videos on corded Milwaukee port bands

@JesusRomero-ek1vl 10 ай бұрын

Hey I have a jack hammer same model and does not hammer. Any advice or is there a way where I can take it to u and you can fix it?

@claudiooliva4665 5 ай бұрын

Hey Dean, great videos! I noticed you use 2 different greases...on one of your previous videos you showed the bottle of the white grease, what's the brand of the brown grease?

@philgallagher1 4 ай бұрын

Bosch 001.

@SkyscrapersConstructionSerbia 10 ай бұрын

I have a problem with one cordless drill. I can't find if it's the motor or pcb is broken. When I press the button, the light blinks once, and when I press it just a little (so that the engine cannot turn even though it does not turn), then the light stays on for 4-5 seconds, which is normal. The motor does not want to start, however when I turn it to several positions it turns 5-6 mm when I press the button. Is the motor or pcb broken?

@deandohertygreaser 10 ай бұрын

Sounds more like something has broken inside and jammed the mechanism

@SkyscrapersConstructionSerbia 10 ай бұрын

@@deandohertygreaser It didn't, I took out the mechanism and it won't, the drill is new, I got it for repair.

@user-cy6yc6tb3t 9 ай бұрын

Badly need my same one looked at dean possible service.

@user-jr8gp2en9b 7 ай бұрын

Sir could I ask you, from which country you are?

@bayadere8308 7 ай бұрын

Ireland (Eire).

@tommyk86 10 ай бұрын

where can you get parts for one of them?

@philgallagher1 4 ай бұрын

Dean usually says just to type the name (or better yet the reference number if you can find it) of the part into Google and you should get loads of shops offering to sell them. As a distributor, Dean gets all his parts either from his own stock or direct from the manufacturer. Hope this helps.