That is a great video! My wife's Bosch was purchased originally in 2007; the motor stopped today, and indications are the brushes are worn out again. This will be the third set i have installed in this washer. I have not had to repair anything on this washer but those carbon brushes. They are relatively inexpensive and thanks to your video, will be easy to change. I remember a little of how it is all put together from doing the job twice before, but thanks to your video I will easily swap them out again, no learning curve required now. Thank you sir for posting this information!

Just wanted to thank you for taking the time to make this video. My wife wanted to purchase a new machine, but with your expert guidance it’s all fixed for under £10! So thank you very much sir!!

Thanx for this instruction Stuart! Saved me a expensive repair job! Specifically the details on removing the motor and connector without damaging or hurting was helpful.

Thanks for the video! An easy way to know if the brush is put the right way is to turn the motor by hand a little, you should NOT hear a tic-tic-tic sound, this way the brush mut be put the other way round. I changed the brushes with the motor STILL installed on the machine because I was affraid to take the belt off. (relatively not easy but still managed to do it in about 20 minutes or so).

Spot on. Thanks very much, that saved another call-out. And with a bit of luck we'll get another 9 years out of the machine!

Brilliant video - thank you! Stuff like this gives me hope for the internet :).

Wonderful video and very useful. I have never done any of this before and based on this and other videos decided to have a go at it (slightly different model machine, motor was quite a bit harder to get to as with mine it was obstructed a bit more), seems to have worked like a charm however.

Really straightforward and useful instructions, really easy to follow and made the job of replacing the brushes easy.

Really good tip to put a towel under the motor- mine fell off suddenly & dented the casing a little bit!

Brilliant, thank you so much, straight forward easy to follow and job done.

Very helpful video! I Thank you

Great video!

Thank you- really helpful. Machine fixed!!!

Brush changes are like thumbing in a softy.

Brilliant Vid by this man...(and Mrs lol!)

Super film … thanks

Hi Stuart, I got an E43 fault on my Bosch WAQ 283soGB. There was also a slight burning smell. Is this normal with worn brushes?

Why are the brushes at an angle? In most motors, they are perpendicular to the commutator..

Hi. Thank you for the helpful video. The video is very clear. But my problem is that the motor of my Logixx 8 is stuck and there is no much space. Is there any way to remove a side layer or the bottom layer in order to have more space?

Is that a bosch maxx wfl 2450

thank god for youtube

I removed the motor but there is no where that I could find a carbon brushes?

Quality video

06:19 : real talk

my motor isn't coming off, so annoying

یک تست میکردی استاد