Рет қаралды 834
Here I show step by step how I replaced the crank bearings on my Moto 4 200. The clutch side was hard to get the sprocket hub off and the flywheel side was critical to get right so it will run again!
If you like what we're doing here at Toy Shop and would like to support us then be sure to check us out on Patreon! www.patreon.com/Toyshop9665?u...
Using these links will help me out!
Toolbox Widgets
1/4" drive Socket Widget - a.co/d/29Ux2rs
3/8" drive Socket Widget - a.co/d/5cCi3mT
1/2" drive Socket Widget - a.co/d/8EsPl9s
Screwdriver Widget - a.co/d/5F7EB5Y
Wrench Widget - a.co/d/0qyVzIM
Wide Motorcycle Scissor Jack - a.co/d/fQLQypt
Narrow Motorcycle Scissor Jack - a.co/d/cGDv73u
Umbilical tank setup;
Moton Pro Aux Tank - a.co/d/2hMd2xe
IV Stand - a.co/d/hHiSSGU
Metric #2 Phillips - a.co/d/1qhV0me
Slide Hammer - a.co/d/e8bu3yW
Camera I use to film - a.co/d/9d39Jjm
Mic I use - a.co/d/0V4vNZ7
Visit us at www.toyshop9665.com to see what we're up to and to check out everything Amsoil has to offer!