REPLACING front upper A-arm on TRAXXAS 1/16 scale MINI E-REVO

No video

REPLACING front upper A-arm on TRAXXAS 1/16 scale MINI E-REVO

Рет қаралды 6,557

Күн бұрын

In this video we go over how to replace an A-arm suspension piece on the 1/16 scale Traxxas Mini E-Revo monster truck. The video goes into detail about the tools needed to complete the task as well as what to look for when replacing the part.

Пікірлер: 19

@michaelrowe5896 2 жыл бұрын

Thank you Full Flex RC! I've been out of the hobby over 20 years and forgot almost all of this stuff 😂

@montyhughes3195 Жыл бұрын

Oh thank you very much. You are so simple and I can go riding along with you. Thank you have a good day.😅

@dj_mayne6908 2 жыл бұрын

Thank you! I don't want to mess anything up worse than it is. I am new to RCs as a hobby

@Elijahthishandleisntavaliable Жыл бұрын

Thanks, glad I looked it up. Thought this would be a much bigger job!

@madmaxx8423 2 жыл бұрын

I have to do this tomorrow wish me luck haha all I have is the tools that came in the box and some random tools around the house

@greggaxiola Жыл бұрын

Well Done Sir!!! Thank you, thank you

@420jozef Жыл бұрын

Thanks! Very helpful.

@mikemcgrew71 3 жыл бұрын

I like that you didn't have to remove skid plate and other pins...

@recallweers3002 2 жыл бұрын

Thank

@f13killerhocks94 Жыл бұрын

Great video! Easy to follow!

@tykahler8088 3 жыл бұрын

Sweet man. Thanks

@josephf2157 Ай бұрын

I have a question about this? the little silver ball poped out of the " A " Arm from the hub carrier.. how do i get it back in there? any tricks?

@pugs333 4 жыл бұрын

Thank you

@Hella916 2 жыл бұрын

How do you fix the front end alignment of the tires ? I have one tire that’s pointing outward 🤷🏻‍♂️

@mxmaniac6 11 ай бұрын

Late to the party, but there should be two screws on the very end. A top and bottom screw. One is for camber one is for toe. Look up 1/16 summit alignment.

@synus81 2 жыл бұрын

hey, found this channel when I was searching for some advice on how to fix mine. can you tell me what milimeter the crosswrench is? I want to see if I can find it in my garage.

@fullflexrc5513 2 жыл бұрын

The wrench I think you are talking about for the wheel was a 7mm nut driver, the size to remove the upper screw I think was a 2mm wrench. I hope that helps you out.

@damiangarcia1550 3 жыл бұрын

Thanks the part is un expensive 8 usd for the whole set but I am sure there are people who will trash or buy a new RC. I will keep fixing mine, any improvements or tuning that can be made to this model?

@bjovi94 3 жыл бұрын

Not too sure about aftermarket support for the small vehicle. They probably make some aluminum upgrade parts for them though like control arms and the suspension pushrods. Other than that, I am unsure.