If that retaining clip is hard to loosen/corrosion welded to the plate, you can look through one of the air vents on the side and tap the clip with a thin screwdriver. Likewise, when reassembling, you can peek through the vent holes and make sure it isn't blocking the reinsertion of the armature.
@CynthiaNakaya Жыл бұрын
Thanks for the video.
@marcosperales7349 Жыл бұрын
You're welcome
@addaeus11 Жыл бұрын
I use the old bearing to sit on top of the new bearing and then bang it on
@Jared_Albert7 ай бұрын
Thank you!
@MariJani14 ай бұрын
I got my women power. Gracias Your video was super helpful,I appreciate it.
@nunya63792 ай бұрын
Can I use my old bearings from my old pump if they r the same exact pumps?
@marcosperales73492 ай бұрын
If they're in good condition, of course. New bearings are usually pretty inexpensive though.
@DanOKC9 күн бұрын
New ones are so cheap why would you? Why repair with bad parts?
@JAYY_JAYY7 ай бұрын
What is the cost to rebuild one of those ?
@marcosperales73492 ай бұрын
It depends on the size of the job. If I'm only doing this... 250.00. Sometimes, the bearings are hard to get or expensive. Remember to judge whether the job is worth it or not.
@derekdriver2512 ай бұрын
Where did you get the bearings
@marcosperales73492 ай бұрын
Amazon.
@ML-dc4qw4 күн бұрын
Useful info, but not a smart work surface.
@weldonlilley4 ай бұрын
This is a poor excuse on showing people how to replace brgs u didnt dhow anything about the govenor switch
@marcosperales73492 ай бұрын
There is no governor switch. Single speed? Single capacitor.