Great video only thing I done different was Heat…

Informative, gonna be trying this when parts come in bent an axle and housing hope it goes as smooth

The small washer on the right side goes after the big washer, then your flange nut

Thanks for the how to video Tim. I've changed the outer bearings on both my rancher and the foreman. Never done a axel swap but I think the rear ends going out on my yamaha big bear 2wd. Looks fairly similar.

I think I would be building a socket for those babies. Have it for next time. Lol

omg i love this guy rock on brother

Well I'll be damned, there is a guy out there that cusses and burps while he works on his shit just like me, my wife don't know nothing.

I was not able to get the new axle in far enough to properly mount the brake drum. I used a block of wood and a hammer and managed to hammer it in a bit farther but still not good enough. I laid the axles next to each other and they look 100% identical. Any ideas on why it wouldn't go?

Should I add some grease to me rear axle before installing it?

First one good video

Does the sleeve on left side need to move or should it be tight. Hopefully you see this

Maybe stupid questions, but did you have to drain the diff fluid ?

Hey man where did you get that stretch?

How often do u have to replace axles and diffs on that bike

I do not think that baby washer goes on first.

the lock nuts on axle use a 30MM open end wrench, if u have one available

Tell them girls come over and help you with that shifter!

Nice how to vids!! Too bad this was not shot in canada, could have legally smoked a loaded cigarette, eh" while filming😊

That is definitely not the right way to tighten the inner nut. It’s funny how in part 1 you say don’t tear stuff apart if you don’t know what you’re doing. I watched this video to try to figure out the torque specs for the double nuts. Refer to Partzilla’s video on this section for the proper procedure. Inner nut is only 29 ft lbs. it doesn’t hold your axle in, just holds the drum on. You’ll wear the dust seal out real quick and load up the bearing by cranking on the inner nut like you did with a pipe wrench. The outter nut is 94 ft lbs and is only there to keep the inner nut from backing off since it’s a very low torque.

Is that a stock axle?

Where can I find that rear differential extension piece

What if I can't get spacer off that's between chunk and locker nut

Would you happen to know we’re a could find a axel for a recon 250

Outback tomorrow for Halloween 🎃

Hi you doing

My axle broke in the same spot

Me and my friend were out on the quads today an hour after i got home he texted me the police are at my house they asked did you see anybody on two red quads he said no lol there looking four us

I will not hold Dallas against u I have quit nfl too !!!!! Watched whole video don’t have a Honda lol

I dont watch NFL either, since they take a knee for the national anthem.