Replacing RUSTED Anti roll Bar Link on 2010 Mazda 6 (GH)
Рет қаралды 1,171
5 ай бұрынStep By Step on how to change the Antiroll bar end link on a 2010 Mazda 6 GH. (Even if it's Rusted and impossible to remove)
Other names are sway bar link, stabilizer link
antiroll bar link link: www.ebay.co.uk/itm/115965633540
#mazda #led #diycar
Disclaimer:
Due to factors beyond the control of Klavs, I cannot guarantee against improper use or unauthorized modifications of this information. Klavs assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. I, Klavs recommend safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Klavs, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Klavs.
@CasSpell
I never understood the engineering behind spinning threads, because situations like this where angle grinders are needed is way too common 😂 If i see there is room for one, i use it straight away when link bars starts to act up like this 😅 Now i know i need to be prepared when doing this on my Mazda 6!
@mirceabarca5828
Instead of cutting the nut, you can use locking pliers to block the spinning when you use the spanner with the nut. This method is ok only if you want to replace the link bars, you can't use them any more.
@alandriver9916
Great video as always, but shouldn't you have put copper paste in the new bolt?
@xlev6
Hi how are
JM Auto Repair
Рет қаралды 772 М.