Рет қаралды 87,189
Replacing the air filter on a moped alpha is a big hemorrhoids, it takes a lot of time and effort. I DO NOT AGREE with this, although many say so. Yes, the location of the casing with the filter is not entirely successful, but with a little effort, patience and time, which is about 10-15 minutes, everything is easily disassembled and assembled. Most importantly, the filter works !! It really cleans, and this is very important, since when dust, dirt and water get lost, it will lose power, stop idling, and much worse cause deformation of metal parts, large particles will leave deep scratches on the cylinder and piston. In this video, I will show in detail how to disassemble and assemble, replace the filter. I advise you to heat the casing with a hairdryer, it helps to stick it into small holes. ATTENTION! Some structural elements of the ALPHA moped may differ from yours, but in fact everything else is the same, including the filter element itself. #filter replacement #air filter #mopedalfa #alpha filter📌 Filter change every 1500km📌 Remove the lining on the left side (1 bolt)📌 Remove the saddle📌 Remove the battery and everything that holds it📌 Disconnect ground📌 We remove a collar or a spring from a branch pipe vf📌 Remove the pipe (you can unscrew the carburetor for convenience) and push it through the hole in the frame📌 Check for dust, dirt, wash and put everything in the reverse order📌 Set everything in place and assembleGood luck to everyone, ask questions in the comments, subscribe!