The innermost secret. Thanks for producing these videos. Keeping the flame and the spirit alive. Watching these presentations is like being an apprentice to a master. Thank you!

Rather than prise out the clock a much easier way is to remove the small copper circlip at the end of the shaft holding the most significant dial in place. You can then slide each number along and rotate it. Once they are in the sequence you want. push them back together and replace the circlip.

Thanks for passing on your knowledge Peter. It’s really helping me fixing things on my bike first go without damaging things. Really appreciate you producing all these videos. Cheers Jeff

Thanks really helpful 👍

H Peter. I got my faces from Image Works also. Reasonable price (considering I ordered 2 sets, and he sent 3). Also included water temp faces, but the temp gauge face has raised markings. Do you replace the face on the temp gauge? I'm guessing you could remove the raised areas on the face before placing the sticker. Cheers from Australia, Mike.

Hello friend, can you please write me the exact address of the e-shop where you buy new faces for speedometers and tachometers suzuki GT 750? Thank you Daniel

I have seen a lot of restorers using acetone to clean and revive the rubber gaskets. Do you recommend that? Do you use silicone as well?

Hi, that's really helpful, mines a J model so plastic instead of glass and no metal ring so a bit tricky to get apart. Can you tell me where you obtain the new guage faces, mine are very faded. ?