You will get inacurate with this kind of method. To get accurate alignment, You must connect both shaft with install the coupling bolt and turn simultanously between driven and load shaft. Good luck

Very good job

Jberdast Vedio

sir pehla dial ka bara tu bathain.ye 90 nova kaya ha.dial ka 100 divisions hain so least count ho ga=1/100=0.01mm yani dial ki 1 div equal ha 0.01mm.or is main ju graduations hain jaisa 0 10 20 30 40 50 60 70 80 90 or phir zero. ye hain 0mm or 10x0.01=0.1mm phir 20 equal ha 0.2 mm or is tarha so on ye 85 ju ap na parha ha ye 8.5mm nahi bhai jan ye 85x0.01=0.85mm ha ok sir. top reading +bottom reading=side reading+side reading is sa hum 3rd reading ju support ki waji sa na par sakhain us ko maloom kar saktha hain.correct me if i am wrong

Sar moja 2 din ki bad alignment Karen hi pump mono aur motor ke to kon kon sy tol chahyi 1 taim karney hi

Jabardast please aisi video aur banao

Bhai device set keise kiye clear kar diji ye

Nyc video and such a informative technicque

Sir aapka pas fhitar milega kiya 25salary

What measurements

Axial agar +hai to and radial -hai to ham side kaise milage

Everything is ok but you didn't tell yet shim correction method Please tell to your all subscriber

Rim-and-Face alignments should be performed with the coupling intact. Running the dial plunger across the opposing coupling surface without rotating that surface with the mounted dial indicator is about as inaccurate as you can get. www.petersontools.com

Aage ka video bheje

Is watch ka naam kya hai

More dial gauge post

7:28

Sir paper पर radial and axial alignment की reading lene ke baad kaise alignment karein baatye

Sir axial bhut jyada tirchha h usse koyi dikat to ni h n

Allingn kider Kiya Kuch bhi video

Nice video brother kzfaq.info/love/m8mQZIpspdf_tT6mNVkX_A

Bakwas Allingment...

Biliul hi alignment vedio me kuch nhi amjh aya bakwas

Bhaijan aapka number chahiye.