I like that it lights up.

I would suggest, making sure the 6 E1's are installed properly, E1's are installed early in Section 5. Make sure P7 (Acrylic Tube) is filly seated, P7 is installed late in Section 5.

I think the advice I would give is to take your time and don't rush. Verify the orientation of the pieces that have printing on them, I have made this mistake a few time. Pay attention to when and where pieces should be waxed. Have a look over the instructions before starting. Should I think for more I will let you know. Should anyone else have suggestion please respond.

The switch to turn the light on and off is on the bottom. It's on the part the houses the batteries. Here is another version of this video. Its at normal speed. kzfaq.info/get/bejne/nOCTl9Rl3detm40.html

The light will shine as long as the switch on the bottom is in the on position. The light will shine if the lamp is turning and if it is not turning.

@@rgauck thank you very much 🙂. Today I finished the ferris wheel. That was my first puzzle of Robotime and I had so much fun. I think I will try now the lantern.

The ferris wheel is one I would like to work on. It's on my to be ordered list.

@@rgauck I wish you good luck and a lot of fun. I just started with the lantern. It's pretty difficult 😳

The gears on P1 may have a bit of grease on them. I would think you could wipe down any non moving parts.

@@rgauck okay thanks 😊

P11 is a LR44 and it requires 3 of them.

I have uploaded a video of B6 being installed. Let me know if it helped. It can be found here kzfaq.info/get/bejne/pbyTqcudl9qvdYE.html

I did buy it from Amazon. Here is the link. www.amazon.com/gp/product/B08P6L9JH3/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1

Dies ist ein Link zu einer normalen Geschwindigkeit Version dieses Videos. kzfaq.info/get/bejne/nOCTl9Rl3detm40.html