In addition, I will tell you how to install a drainage system.
Tool used:
1. Screwdriver with PH2 bit
2. Screws 4, 2x13 with a wide cap
3. Mounting knife
4. Multi-tool
5. Roulette and pencils
To begin with, we measure the G-profile and cut it off with a multi-tool. We tear off the stickers from the profile. First, we mount the long parts of the G-profile, following from the top to the bottom of the roof overhang. Work much faster with the construction of prefabricated steel scaffolding, although they swing due to the inability to tie them to the house. For safety reasons, it is better to put the supports of the scaffolding or stairs on a solid, stable base (to lay either large pieces of timber or slabs of DSP). To avoid jamming of the G-profile, you should install a torque limiter on the screwdriver at the initial divisions (I have 2).)
Next, we make the lower part with 2 corners. In order not to use the protractor, we make marks on the G-profile and draw the hypotenuse of the cut isosceles right triangle on them. We saw off with a multi-tool according to the drawn one.
When the G-profile guide is ready, we attach the spotlights. Each on 2 self-tapping screws, inserting into each other. The last one is inserted into the finishing bar.
The drainage system is fixed with special brackets, which are fixed on the wall in increments of 40..60 cm. It is necessary to fasten the gutter at an angle, choosing the appropriate height for fixing the brackets to the wall. It is better to start with the upper ones. A thread is stretched between them, and then the rest can be easily exposed with a uniform slope towards the drain.
The downpipe is connected to the gutter through a special transition unit. 2 rotations of 45 degrees are used. A pipe with a diameter of 80 mm is used. In accordance with it, the brackets for fixing the pipe to the wall are selected. Mounting step - 50 cm. At the junctions of the pipes, transition couplings are placed. Snuzu is placed a special element at 45 or 67 degrees.
Under the lower part of the inner endowment, a water intake bath is made from a gutter and 2 end finishing elements. This structure is attached to the wall with a bracket. We put 2 angles of 45-degree rotation, the pipe is fixed with brackets with a step of 50 cm. We use couplings. The video shows the bottom element at an angle of 67 degrees.
Contacts for communication:
Telegram-chat channel warm house: t.me/joinchat/HeA9BBrjNJ2Doqn...
Contact phone number in Saint Petersburg (Moscow time): +7 951 6742 777