If your Prusa lands in our shop in this state, it'll leave with fresh 13mm/5mm textile harnesses on E/X/Y axis and no spiral wrap; that spiral harness wrap will abrade your cables over time - that Einsy enclosure is old style with no clamping yet the X gantry is freshly printed, and that bed wire looks like a saggy diaper with the - only briefly shipped - 8mm "fat" textile harness wrap; another pro-tip: you can use the MK4 style bed clip which is "reinforced" with a length of nylon filament to protect the bed harness. Either way, it's a bit odd to see such an "old school" MK3 with such a mishmash of parts. Cheers and keep on printing. 🗿👍

Hello, 7:01 Why have the cable ties suddenly disappeared and the bearings are no longer aligned with the Edding line, as can be seen at 06:05?

Why are you showing the old outdated cable covering and strain relief, and why does the cable cover end before the cable support on the back of the X carriage? this will concentrate flexing, at that point on the wires. leading to early failure

Can I ask you to make a video of printing with Belt nozzles?

The mounting of the cable sock is problematic. The sock needs to go on the cables before the zip ties, then it will help stiffening the joint instead if concentrate the flexing to a small area.

Attempted the process and can't get the filament to load, like the extruder is not working, any ideas on how to confirm operation?

Hello! I ordered Revo Six. - What is the correct name for the connectors on the hotend? - Which switching boards are suitable for installation on the print head? - Which 24V power supply should I choose (Heated bed 200x200 mm)?

A quick question if I may, Will this also work with the MK3.5? I have many Mk3s and Mk3s+ units but looking to upgrade to MK3.5 If you have any test units you may be able to send out I will gladly trial one 🙂

Hello! Why is "Revo Six" only in the bowden version? Can find a radiator for installation in the direct version of the BMG?

What version of the MK3 is in the demo? I have a MK3S+ and it doesn't;t tension the belt like in the demo.

Why are you wearing gloves when working on your 3d printer? It's not like working on a car. lol

why would i do this uprade, is there a particular advantage?