How do I extra all the tags on the program and transfer it to the same program . Because I had to hit the crest new when logging on the old 500. It upload the program but with out all the tags / disceiption . I have the original program with all the tags but now the old uploads them with out the names

El piloto verde de la red DH485 debe estar flacheando, o debe estar prendido sin flachear ?

can i change out one that does not say OCTAL on the front. but it does say 115 VAC

Please Does the serial cable have 1 to 1 or rx / tx connection? Pins 2 and 3 must be reversed thank you

Thank you. It was very helpful.

Awesome instructions - Thank you

Could you help me with the installation files for communication?

Thank you so much!

thank you very helpful

One cuestion: el PLC SLC 5/03 CPU cuando esta en marcha o en trabajo debe estar la llave en RUN o en REM ?

I am using messung nexgen 4000 PLC i am getting memory error LED and not communicating with PC help me in this regards thanq

Thank you. Very usefull.

Painful...but helpful.

thank you .

THANK YOU

Esto sirve también si ya tiene un programa y solo quiero leer lectura serial

no logro ver la conexión, se supone que se conecta el cable L(linea), en donde dice 120/240 VAC, Neutro al Neutro

He never mentions at 4:10 that the driver in the Configure Drivers window is showing that it is has a status of "running" which is critical and shows a successful driver configuration.

thanks

Thankyou

👍👍👍👍👍👍👍👍👍👍

it is much easier to connect and a faster connection using DH-485

Todo

Ghanés. First tutorial technic correct