RUST REPAIR ON A VW BUS!! REPLACING ALL THE LOWER PANELS WITH PATCH PANELS ON A VOLKSWAGEN VAN
Рет қаралды 8,428
Күн бұрын#REPAIR #FABRICATION #RUST
Replacing the entire bottom sheetmetal on a 1977 vw bus. about a dozen patch panels installed.
THANK YOU VERY MUCH FOR WATCHING!
PLEASE SUBSCRIBE, LIKE AND SHARE!
it really helps the channel grow.
also check me out on facebook and Instagram.
/ caseyscustoms
/ caseys.customs
@clasicradiolover 6 ай бұрын
Interesting to go back to the older videos
@butters8.013 2 жыл бұрын
Made that look possible for the DIYer. Thank you
@phillumenistfilms 2 жыл бұрын
What was the full charge $$$ after all the work was done?
@bubbleheadd 4 ай бұрын
Hey I was curious do you have any idea for fixing warped fiberglass? At the top of my camper the luggage area on the passenger side is popping up from its seal about 2 inches is there anyways to flex that back down and make it stay say with heat, or does it have to be redone?
@mickholgate3347 4 жыл бұрын
good job Casey!
@CaseysCustoms 4 жыл бұрын
Mick Holgate ty sir!!
@themechaos8831 3 жыл бұрын
@@CaseysCustoms Hey great work man! I recently got a 1969 VW bus and it has a fair amount of rust as well. I was wondering if you could tell me the cost to do the repairs in the video, so I can get an idea of what I'm in for. Thanks!!
@CaseysCustoms 3 жыл бұрын
@@themechaos8831 shoot me an email with pics and I’ll get an idea for you. Caseyscustoms@yahoo.com
@themechaos8831 3 жыл бұрын
@@CaseysCustoms Oh wow, that would be super helpful. I will send the pics tomorrow as it is dark now. Thank you so much my dude. You a real one.
@juniorclassicvwbugs924 2 жыл бұрын
Hi there do you have a vídeo Clip of this video showing in normal speed what you were doing in the sliding door track?
@geoffl838 2 жыл бұрын
I wasn't able to tell from your video...did you butt joint those repair panels to the original after cutting away the bad, or did you overlap and weld, or did you overlap and plug weld? Also did you use filler?
@noahvarias4861 3 жыл бұрын
For the interior portions of the pannels you welded on, did you paint/treat them at all for rust or other protection?
@CaseysCustoms 3 жыл бұрын
Yep, i always spray the inside with sealer and/or undercoating
@jonathanparra1810 7 күн бұрын
Wtf bad Job
Vangabonders
Рет қаралды 31 М.
Vangabonders
Рет қаралды 21 М.
ChrisFix
Рет қаралды 8 МЛН
Campovans Custom Vehicle Conversions
Рет қаралды 314 М.
Sửa chữa đầu đĩa oto, lắp đặt nội thất oto
Рет қаралды 2,5 МЛН
КИНОТАЧ
Рет қаралды 943 М.