Saito FA-82 with Perry fuel pump and glow driver bench run with APC 14x6 is spinning very well. Now using 5% nitro, but in future will be 15-20% for better idle.
Пікірлер: 8
@ROCKYBOTTOM1111 күн бұрын
I had trouble bench running mine as the data sheet it came with said set main jet at 4 turns. Way too ricj even for running in. What did you set yours to?
@mattiananni14503 ай бұрын
Hi, did you have difficulty adjusting the pump? I have it on a 125 Saito and I'm going crazy, the maximum is fine, but at idle I barely accelerate and it's always fat and slow to rev up, even if you adjust the pump to idle and I close the idle needle. Did it take you long to adjust it? Thank you
@Irvine7214x6apc5 ай бұрын
This engine is about 1,200 rpm above what it should be doing with the APC 14x6 prop - did you get all that extra performance just by the pump? Had you tried it before without the pump at all? I have a VP-20 pump, not your VP-30, do they work the same way?
@mvarzoni14 жыл бұрын
Sir, do you still run that engine?
@Wilmer7878 жыл бұрын
How your system works without the muffler hose to the gas tank?
@scale.soaring8 жыл бұрын
+Wilmer I am using Perry pump to deliver fuel to carburator. Try google search perry pump to get more informations about model fuel pumps.
@MrLupold5 жыл бұрын
Its called a Perry pump!
@zubuxstein3 жыл бұрын
Perry pump are limited to its location in relation to the carburetor.