SATTO Composite Repair using SOLLUX rapid repair system
Рет қаралды 17,579
7 жыл бұрынThe SOLLUX composite repair system enables repairs up to 4 inch dents or up to a 12 inch skin damage from start to finish in approximately 1 hour. Repairs can be carried out In workshops or on-wing, with limited tooling requirements.
No more hot bonders, heater mats or expensive bagging systems.
Watch the complete process in this video.
The system and its engineering support documentation is exclusively available through SATTO Solutions Ltd. sales@satto.aero
@alisonizi4347 Жыл бұрын
You need to use gloves when work with composite material to avoid contamination in your hands and materials...
@mauriciodelgado1 3 жыл бұрын
Gran trabajo y herramienta, guau
@hamedzarif7711 3 жыл бұрын
Thanks
@hamedzarif7711 3 жыл бұрын
It was much better if you wrote here that which ply you are removing from, you remove three ply from each prepreg and after the completion of the curing process I think the first one was backing material, you remove two backing material from the below and the top , then you put a thin layer of fiberglass fabric as peel ply on the top of the repair area, finally, you remove that, it was difficult to realize that.
Aeronautical Precision Engineering Inholland Delft
Рет қаралды 4,9 М.
BorisKateFamily
Рет қаралды 3,3 МЛН
Делай сам
Рет қаралды 4 МЛН
КОПЖАСАРОВЫ БЛОГГЕР
Рет қаралды 297 М.
Mohdhassan_11
Рет қаралды 34 МЛН
iPolina Queen of the Cringe 👑
Рет қаралды 79 МЛН