Рет қаралды 76,867
Since last week's video on this satellite got a lot of interest, here's a follow-up! I wanted to address the most common questions from last time and correct a couple minor errors. I also wanted to try some different techniques of listening to this satellite, including different frequencies and other antennas.
More information on the satellite here: usradioguy.com...
More info on the image scanner system: en.wikipedia.o...
This is the type of rooftop antenna I use, connected to an SDR and Raspberry Pi computer: usradioguy.com...
This is my current favorite software-defined radio for general experimenting: www.rtl-sdr.co...
For better 1.7ghz / HRPT reception, I use a SAWbird+GOES filter/amplifier gadget: www.amazon.com...
The folding satellite dish is a "Cyberex CN7500". I don't think they've been made since the '80s, but this company makes something similar: sub-lunar.com/...
I'm mostly recording satellite signals on Linux using rtl_fm, with the following settings (these might not be the best in every situation, I'm still learning how to do this!):
timeout 15m rtl_fm -M raw -s 120000 -f 137.1M -E dc -g 48 -p 1 (right angle bracket) raw_dump.raw
I'm then using sox to create a wav file:
sox -t raw -r 120k -c 2 -b 16 -e s "raw_dump.raw" -t wav raw_dump.wav
And then I process that wav file with SatDump: github.com/Sat...
I also tried streaming from my computer with the SDR and antenna, using rtl_tcp as follows:
rtl_tcp -f 137.1M -s 250000 -b 16 -a (ip address)
And then connecting from the Recorder tab in SatDump. That seemed to work pretty well. I was told SDR++ works better as the streaming source, but could not get it to install on my Raspberry Pi.
More info on HRPT and antennas here: sgcderek.githu...
I've also tried LeanHRPT, but I did my recording wrong for that: www.rtl-sdr.co...
(UPDATE: I heard that Meteor M2-3 switched BACK to 137.9mhz after I made this, but who knows which frequency they'll finally settle on).
Saveitforparts t-shirts and other merch at saveitforparts...
Join this channel to get access to perks:
/ @saveitforparts
Or support me via Patreon at / saveitforparts