I use a compression gauge tube and add a balloon so you can find top on the compression. Way easier to figure it out.

Thanks always enjoy your King Quad 300 videos,very informative. Not many videos out there for this machine.

your videos helped me get a 95 model back up and running after sitting for over 2 years ty for making all these helpful videos

wassup man. im really glad i found youre channel. im after buying one of this quads in rough shape for a project. and thatnks to you im learning a lot about them. thanks so much man

Thanks very much for the video. I adjusted my quadrunner 250 and no more valve noises 🙂👍

Thanks for this vid! I got 2 quadrunner, and your videos alway help!

Thanks sir for making this video. You helped me tremendously.

your King Quad videos have been invaluable. Thank you from Wyoming!!!

Thank you that helped me out

Great just what I needed thank you

Nice work just got one for $350 it probably need this to Ty for the video 👍

Thanks again🙏

Thanks for vid. Nice info

My quad is hard to start when cold i put choke start shut off like 5 sec after when give throttle die too and after like 1 min finish take gaz and run when hot start easy and run great

i like video on setting valves

Basically the first "repair" i did on mine was to replace the old cap o-rings.

An easier way is to stick your finger over the hole. When valves are both closed, the piston pressure will "pop" your finger off of the hole. If you have a buddy you don't really care for you can put the spark plug against the back of his hand to verify, hahaha

hi! I got a question about my quadrunner 300 1992. The front diff is making weird clicking noise sometime when I turn or push the 4 wheeler when its off. Even if the 4x4 is not engaged. I wonder what can cause that? bad oil? borken gear or something else? The 4x4 still work, but the diff lock i'm not shure.

Question can it stops my four wheeler for bogging out when I'm in like 4 or 3 gear

Great as usual. Love the videos about the kingquad 300. Just aquired a 2000 Kingquad 300 with only 1928 KLM on it but seems like it is stuck in gear because I can't shift any of the levers. Any ideas. Thanks.

Man mine is being a pain starts one time doesnt start another time.. did a carb rebuild on it now it's like almost wants to start but doesn't so fires but just not enough to start almost like flooding.... I give up any ideas?? Could it be value clearance for hard starting?? Thanks in advance

You think both being out of tolerance would cause a lack of power i have alot of trouble keeping speed on hills

Why didn’t you tighten is 10 mm 12 m millimeter bolt

Need help hooking up fuel system on LT185 SUZUKI

what would make exhaust glow red when you hold high idle?

how do you see in there to adjust the front valve, I cant get my head in there to see it?

i have a poping noise when i give throttle is that valves or carb isue

thanks eh! now i know i did do it right...

Mine is quite cold noisy hot

Or you can buy the proper feeler gauges

Hey, what is a valve clearance on king quad 300 99??

Has anyone had their king quad have a very hard start,I mean like starter wines for a bit then will turn over,some times it will turn over a few times but very hard.replaced starter same thing,pull plug turns over fast put finger over plug hole and stops turning over,I’m lost