Congrats man you are never to old to do anything and thanks this video was amazing and now I'm getting the same kind of bike and kit

I hate to spoil your great problem-solving solutions...but they make a bolt-on OCC mounting bracket provides the proper upright tubes at the proper angles at the proper off-set to line up with the rear sprocket. Also, for those who plan to build this great toy, they make lots of upgrade options for better rear sprocket mounting, exhaust, spring-loaded chain tensioner, etc. Less fabrication, better (and probably safer) setups and a longer life expectancy.

I can see you tooling down the road on that chopper, leather jacket and chaps! LOL Nice work so far. That Hill Top Machine Works guy has a not bad idea! Waiting to see the final solution. 'Til next time.

Thanks for posting this video. I enjoyed and learned something in someway. I am wondering, where did you buy the 80cc engine? Thanks in advance. Cheers!

Well, Wheres the finished product?!!!

You should have just used 1-1.25” pipe welded to u channels with u bolts holding the channel to the bottom frame

Curious instead of moving the whole motor like your doing could you make a spud shaft to extend the sprocket out?

Turn the music off

👍👍👍👍👍👍☝️

Its not the only way you have to mount it! They sell plates with the two bars, you sir do allot of unnecessary work. Ive built 3 of these & it was painful to watch you go through all that you did.

Did you just call a bolt a screw?

Lol I feel the same way.to be kid again

how much was all of this