Рет қаралды 839
Using it on a mini. I use max 10psi it is enough and will not risk damaging master cylinder. I released pressure in vessel between doing each calliper and just pumped it up again when I was ready. This tool worked very well.
Note, when you separate the union from the pipe to the master cylinder cap after bleeding your brakes, a fair amount of fluid will spill out of this connector so put a large rag underneath it to stop it going on your car. This is unavoidable because you need to separate the two in order to be able to rotate the master cylinder cap. Otherwise the tubing catches your bodywork etc and you can't turn it.