Рет қаралды 1,210
This is part two of a two part video series where I look into getting this cute little industrial overlocker from the 1940s up and running.
In part 1, I assess the machine head and give it a good look over, lubricate and check the blades.
You can find part 1 here - • Sewing Machine Archaeo...
In this part I come across an issue with the blades and thread the machine to see if it will form a stitch.
A good customer of mine has recently purchased this industrial Singer overedger head and wants me to see if I can get it stitching. The original table and motor is long gone unfortunately but I think we can at least test it by hand to see if it forms stitches.
Subjects covered are listed in the index listing below.
Please consider supporting the channel at Patreon - / sewingmachines
Web Site - www.institches.co.nz
Index:
0:00 - Introduction
0:45 - Blades
11:12 - Left looper threading
15:37 - Right looper threading
17:37 - Needle thread threading
20:28 - Test stitching
26:43 - Differential feed adjustment
31:08 - Stitch length adjustment
34:32 - Conclusion and thanks