Follow along with our Everbilt expert to learn how to replace a shallow well pump. Well pump installation is a relatively easy project that only requires a few tools to complete. For more tips and tutorials, see our Plumbing playlist: thd.co/2Teg80L
#TheHomeDepot #HomeImprovement #DIY
SUBSCRIBE to The Home Depot: thd.co/2iib0HE
Shop Everbilt jet well pumps and systems at The Home Depot: thd.co/2CFdaND
Follow these steps to remove your old pump:
0:44 Change the voltage of new pump before installing
2:02 Turn off power
2:11 Turn off water
2:20 Relieve pressure
2:34 Drain access water from pump
3:00 Remove incoming line piping
3:25 Remove other incoming line leading to the tank
3:50 Disconnect wiring
For help with your installation, follow the steps below:
4:19 Replace foot valve (if needed)
4:54 Check pipe for rust or calcium buildup
5:05 Remove priming plug & fill with water
5:19 Prepare and attach incoming pipes
6:21 Prepare and attach outgoing line
6:48 Install the pipe to the existing piping
7:10 Tighten all pipes with a wrench
7:19 Prime the pump
7:43 Hook up electrical
8:40 Prepare to power up pump
9:25 Tools used in this installation
9:45 Additional items needed
►Follow all local and state codes for this installation◄
About The Home Depot:
How doers get more done. We’re helping doers in their home improvement projects. Now you can take on more renovation projects with more know-how. Our step-by-step instructional DIY videos and expert advice will give you the confidence for your next project with hands-on learning. It’s a good time to be a doer.
Follow The Home Depot:
WEBSITE: thd.co/TheHomeDepotSite
FACEBOOK: thd.co/TheHomeDepotFacebook
TWITTER: thd.co/TheHomeDepotTwitter
INSTAGRAM: thd.co/TheHomeDepotIG
PINTEREST: thd.co/TheHomeDepotPinterest
Shallow Well Pump | Everbilt Jet Well Pump Installation | The Home Depot
/ homedepot