Walk through of configuring the mini r53 shift light / rev display from whatageek designs
Пікірлер: 16
@NSSPhotography Жыл бұрын
One more question… how is the bare wire connection made? I’d prefer to not have a connector on the OBD port so on your bare wire option I’m wondering what wires do I need to tap into in the car?
@whatageekdesigns Жыл бұрын
It needs 12v, 0v and connection to pin 9 of the obd port
@mertcapkin72632 жыл бұрын
looks slick! which electronics did you use inside of it?
@whatageekdesigns Жыл бұрын
Currently use an arduino nano but I'm currently designing my own custom board.
@mertcapkin726311 ай бұрын
@@whatageekdesignshave you been able to design it?
@rendramarta7798 Жыл бұрын
Hai..can i buy it
@scout9012 Жыл бұрын
Does this work on other makes of car?
@whatageekdesigns Жыл бұрын
Only tested on mini's at the moment. In theory if the car has a specific signal wire providing an RPM related pulse signal it could work.
@NSSPhotography Жыл бұрын
Will this remember your configuration after you power off the car?
@whatageekdesigns Жыл бұрын
Yes, all settings are saved in memory.
@qaz12341673 жыл бұрын
Hello! where can i buy it?)
@Thejdog693 жыл бұрын
Hi - Its available from my shop - whatageek.co.uk/shop/shift-light-rev-display/
@qaz12341673 жыл бұрын
@@Thejdog69 Oh is there option to gen 2 mini?
@Thejdog693 жыл бұрын
@@qaz1234167 there isn't specifically, but the electronics will work fine, not sure if the shape of the bottom is compatible but it looks like it might fit
@aldwinmanaois30352 жыл бұрын
Will it work on gti?
@whatageekdesigns2 жыл бұрын
Hi, I dont know - this has been developed to use a specific pin on the MINI OBD port.