Looks nice. Not sure what goes into a new rear end. But, if Andrew Camarata has it, I wouldn't have any problem owning it. Good luck with your decision.

Yes those engines are very good. They are well balanced and they run well and will go for a long time. I have a Brazilian Cummins in line in a B 600 that runs very well. They do sound awesome as well you were right about that they sound like they are the shit

the engine is good,if you have problems, later on with finding parts,you can always drop in a good Cummins motor.👌👍😀

It's clean af brah. $5000 seem like a steal

We have a 1990 it's pretty good but it's top speed is 55

We bought the L series 9000 6 speed trans 55 mph tops but it is stout no downshifting for hills it just plows on 10 ton in or behind it

Accelerator pedal under left foot?

That's what I drive it doesn't have a lot of power but it's reliable

Andrew camarata and j. c. Smith, are really good to follow,this truck is good value ,please tell me you would try to rescue and save this lovely truck👍👌🍓🤩👌

Love the truck,good sounding motor,I also follow Andrew Caramata,and G Smit,👍👌🤩😀🍦✔🍨😋,find out what would it cost to fix the rear end ,ask their advice,its got a really good 7,8 ford motor👍✔👌🍓

It sounds like both a International Harvester/a Locomotive engines!

87 to 91 had 4 of them

I know I'm late, but don't get one. These Ford Brazil Straight 6's are awesome, very reliable for their time, while a bit underpowerd, they can make more when you turn em up, but that's their only positive qualities. Aside from being down on power, their actual problem it's impossible to get parts for them, and if you get one, you might as well buy another engine to use for spare parts. Again they're reliable engines, but any engine 40+ years old is not gonna survive during your time of ownership problem free.

Please get it

I just built one parts are difficult to find. Offer 3 grand

I have one of these motors in my 1994 Ford f 350 with a 5 speed

I have a 6.6 Brazilian they have no power but work good...stay away from hills...lol

I thought they used that engine in New Holland equipment also.

We hal 10 tons on ours we hal a 15 t backco on a trailer

It sounds good its been many yrs since I've dealt with those Ford engines we had some I think those were 365 cid don't know how that converts to litres those came from England though and those had liners so you could've rebuild them to like new condition those were very reliable engines if it's the same like the one I mentioned I'd get it

Not a 98 87 to 91 had 4 of them

Ive heard the Lucas Gillingham brakes on Fords are probablematic and expensive