B1P-9-E | Siemens NX 2007 Tutorial Modeling | Welcome to our VIP lounge for young experts. Two practical problems and the simple solution. 1. An edge blend should be tangential only in selected areas. 2. The shaft diameter and the chamfer are to be controlled via the thread. Expert courses deepen the knowledge of the training content already shown. Possible solutions are demonstrated on the basis of special problems, some of them from practice.
▬about this channel▬▬▬▬▬▬▬
With LearnNX you will learn Siemens NX step-by-step from the beginning. The basic course consists of learning videos that build on each other. (marked blue)
You start here: • Siemens NX Tutorial | ...
In between you can check your knowledge with tests. (marked green)
Expert exercises impart special knowledge. (marked red)
All learning videos are available for free. We look forward to your comments on KZfaq. (and about your subscription ;-) / @learnnx
▬about our free learning platform▬▬
😃 All tutorials, clearly arranged, can be found here: learnnx.com
Learning videos with a short description, together with the exercise materials as download.
You can also search 🔎 for commands or topics.
And all according to the motto: step by step / for free / for all 🎈
▬chapter▬▬▬▬▬▬▬▬▬▬▬▬
00:00:00 Content
00:00:11 Foreword expert course
00:01:22 Foreword
00:02:18 Create base part
00:02:18 Sketch
00:03:31 Revolve
00:03:42 Hole
00:04:13 Edge blend R6
00:04:26 Mirror features
00:04:43 Hole
00:05:03 Edge blend R5
00:05:13 Trim body
00:05:41 The special edge blend
00:07:16 Thread controls shaft diameter
00:08:39 Reference dimensions
00:10:25 Conclusion
▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬
► visit us on learnnx.com
#learnnx #SiemensNXfreeCourse