Skoda Fabia III (NJ3) - Reversing Rear camera installation

Рет қаралды 9,058

9 ай бұрын

Android Head unit upgrade from Swing:
• Skoda Fabia III (NJ3) ...
Android head unit car setting menus:
• Skoda Fabia III (NJ3) ...
Accessories :
• Android head unit acce...
Reversing Rear camera installation:
• Skoda Fabia III (NJ3) ...
-----------------------------------------------------------
How to support the channel:
Donate to our PayPal:
paypal.me/GaborBodri
Subscribe to my youtube channel:
kzfaq.infonoo...
---------------

Пікірлер: 17

@jinayorobo 7 ай бұрын

Cool vidéo

@spedyhgw 3 ай бұрын

Which cable do I have to use from the radio?

@maciekserwin6028 8 ай бұрын

Could you link the camera? Just I bought v7. Do you think there is any posibility to connect more than one cameras, for ex. reverse and front camera? Surely there is no chance for 360 cameras?

8 ай бұрын

I used this camera:

@waynepeck466 4 ай бұрын

Where did you pick up power and earth for the camera from, was that included in the wire you ran to the front or did you take from the reversing lights?

4 ай бұрын

I connected the ignition switch voltage to the fuse box. Grounding: from there at one of the screws that is in good contact with the body.

@spedyhgw 5 ай бұрын

Can you tell me how the holder for the rear view camera in the trunk lid was built? Is there a link or instructions on how it was built

5 ай бұрын

In my case, the factory holder held the opener with straps from the side. (This may differ) That's why I had to bend 2 pieces of iron and drill them through. The bent sheet supports the camera on the rear door frame at its two edges. And the camera is turned onto the metal plate with the 2 screws, so it clamps them together.

@spedyhgw 5 ай бұрын

@ thank you

@jinayorobo 7 ай бұрын

Could make a video about installation of front camera?

7 ай бұрын

Maybe later. I haven't felt the lack of a first camera yet.

@harynian 3 ай бұрын

These guide lines are too down, making them unusable.

@spedyhgw 3 ай бұрын

Hello, I installed the same camera as in the video. Unfortunately, I don't have a clear and consistent picture. How did you connect your camera? We had to lay an additional continuous power cable because the camera does not receive power when the engine is on, only when the ignition is on.

3 ай бұрын

I used a 5-pin cable. GND- even good together. (camera, power) 12V ignition-switched voltage from the fuse panel (e.g. seat heating) Camera - camera signal (yellow wire) . The camera signal must be connected to the desired radio input. I made a modification to the cables coming out of the camera unit so that it can be disassembled.

@spedyhgw 3 ай бұрын

@ I will try this with a signal filter, maybe that will solve the problem

3 ай бұрын

@@spedyhgwIs the reversing camera image set correctly on the display?

@spedyhgw 3 ай бұрын

@ Yes, I tried everything until I found the right setting, but the picture still flickers when reversing