Slot Car World Championships - Handling and Setup is critical in 24 EuroSport

Slot Car World Championships - Handling and Setup is critical in 24 EuroSport - Part 1

Рет қаралды 2,957

Күн бұрын

1/24 #scale EuroSport is the fourth and final class at the #slotcar #worldchampionships . I learnt a lot during this class and made a big #mistake with car setup.
In this two part video we take a look at the car I used and I give tips on motors, gear ratios, tyres, body and chassis setup.
CleaveTech contact information:
Facebook: / cleavetech.co.uk
Instagram: / cleavetech
KZfaq: / cleavetech
Web: www.cleavetech.co.uk/
Email: cleavetech.james@gmail.com
Slotblog: slotblog.net/forum/506-tech-ti...

Пікірлер: 14

@MK-yu1di Жыл бұрын

Great stuff, enjoying the race highlights and insights.

@CleaveTech Жыл бұрын

Thanks very much for watching.

@John-te3zd Жыл бұрын

Good information Cleave, love your videos

@CleaveTech Жыл бұрын

Thank you 🙏

@keithwthe1andonly 6 ай бұрын

What would you do if the car was chattering coming off the turn?

@commodiusvicus 10 ай бұрын

How are these so much faster than 1/32 in the USA?

@richparks1966 Жыл бұрын

What a Cleave Cliff Hanger, Or tease'n git move?

@CleaveTech Жыл бұрын

Haha. 😉. All is explained in the next video.

@CleaveTech Жыл бұрын

Thanks for watching though 👍🏻

@richparks1966 Жыл бұрын

@@CleaveTech For the lack of a guide shoe spacer, you were running a street/track sweeper.

@CleaveTech Жыл бұрын

Yep. Didn’t work in those conditions but if the rubber wasn’t so sticky or so deep, it does work.

@richparks1966 Жыл бұрын

@@CleaveTech Sure, it's all about judging where the rubber (build-up) meets the road. You ran a snow plow. I'm sure that set-up would work on a clean track if you can identify one in time. Next time I'm sure you'll be shim washer ready.

@garyrapp8676 Жыл бұрын

Why do you use sooo much lead wire from motor to guide flag GARY RAPP USA

@CleaveTech Жыл бұрын

I’m not sure what you mean? The lead wires are only just long enough to reach the bus bars on the motor. I am not sure how they could be any shorter. I sometimes make the lead wires slightly longer to allow them to be looped near the guide to reduce the stress on the joints.