Really nice trailer

The wheel wells are junk and every one I have seen around town has the wheel wells sagging. It then creates cracks everywhere at the end corners and center as the saggy metal flops up and down as you drive. I had to weld all the cracks and added a 1x1 square tube center support off the shackle/hanger mount up to a plate welded to the bottom of the wheel well, then it was 100% fixed. In the end if they are going to keep using less than 1/8th" wheel wells they need to add center supports. Oh, the ramps barely hold an 8k lb excavator, I plan to add tubing on the underside of the ramps where the edges are bent under like c channel. Those bent under edges flared out so I had to use a sledge hammer to bend the "c channel they formed" back under it straight so it wasn't too wide and would fit in the ramp slide-in mounts. The ramps are straight and not sagging but they flared out at least 1/2". Luckily I have only had to rent an excavator 3 times. Otherwise it's been great.

Did they forget the floor supports?

Mine came with lots of rust under the finish and a bunch of defects. I'd never buy from them again.

Chevy, lol.