Рет қаралды 14,605
I show you how to replace and bleed the brake fluid on motorbike and scooter. I do this on a Moto Guzzi Nevada but the operation is similar on most vehicles.
I replace the brake fluid by sucking it on the forward brake.
This video isn't sponsored.
This video has been created for practical, educational, and sharing purposes. It neither constitutes nor replaces a genuine specialized technical manual. EnjoyWheels provides no warranties of any kind and disclaims all liability for the information contained in the videos.
Under no circumstances can the author be held accountable by viewers for any adverse effects resulting from the use of the information presented in the content.
EnjoyWheels recommends wearing personal safety equipment when carrying out tasks similar to those shown in the videos on this channel.
If you are uncertain about the potential dangers of an operation, its consequences, or your own ability to perform it, seek assistance from a professional.
The rear brake is more complicated on this motorbike because there are 2 high points where can have some air. This causes the brake to be not working.
I solve the first high point by moving the rear caliper upside down.
Then I open the rear master brake cylinder where has a high level too.
I bleed the rear brake fluid by pression.
0:00 Intro
0:35 Forward brake liquid replacement and bleeding
4:44 Rear brake presentation
5:54 Rear brake caliper upside down
6:20 Rear brake liquid replacement and bleeding
11:34 Rear master cylinder bleeding
14:52 Final reffiting and conclusion
If you like this video, you can add comment, share it, add a thumb up or consider subscribe
See you soon on Enjoywheels !