Stained Glass Art DIY 2024 Soldering & Patina Techniques

Рет қаралды 3,249

10 ай бұрын

Free pattern download link: cavalliniglass.com/products/b...
This is the third and final video in the series about this honeybee stained glass art project. This video is made to help you learn how to solder copper foil styled stained glass art projects. In this video, we use the basic tools and techniques required to solder, patina, and finish out this honeybee stained glass window. If this is the first video you are seeing, you may want to go back where we have a few other videos on this project. First demonstrating how to cut the glass and second how to copper foil all of these glass pieces.
Links to soldering tools & supplies:
Soldering Irons: cavalliniglass.com/pages/sear...
Solder: cavalliniglass.com/pages/sear...
Flux: cavalliniglass.com/pages/sear...
Patina: cavalliniglass.com/pages/sear...
Soldering accessories: cavalliniglass.com/pages/sear...

Пікірлер: 14

@davidhill1220 5 ай бұрын

I cut my zinc with a Dremel drill Very easy and smooth the ends with a sanding bit LOVE the bee Thanks for all the tips I’m a new subscriber Patricia

@Mr.StainedGlass 5 ай бұрын

Thank you!

@flixalicious2424 10 ай бұрын

Pretty good stained Glass soldering tips, thanks

@Mr.StainedGlass 10 ай бұрын

No problem 👍

@peaceandcreativity4636 9 ай бұрын

Your magnificent work ❤️ is so inspiring 👍 I would love to learn this technique... added you in my subscription list....so I would be able to watch your videos.

@Mr.StainedGlass 9 ай бұрын

Thanks so much 😊

@ellagregory818 10 ай бұрын

I like soldering, I'm just not good at it yet and I get so frustrated. Im new and haven't made too many pieces yet . I hate it when I get one side looking ok and then flip it over and do the other side then when I flip it back over the first side that looked ok, looks terrible .

@Mr.StainedGlass 10 ай бұрын

Just takes some patience! It sounds like after you get one side looking good, before going to the other you need to let it cool down because it keeps running through. There also may be some big voids between the glass so you may need to recut some pieces before starting to solder on the next project. Let me know if I can help out anymore!

@AnOlderGayGuyShow 17 күн бұрын

I put a clean damp dish towel in my freezer a half hour or so before I solder, then I lay it under my project. It keeps the solder on the other side from heating up too much when I'm doing bead soldering. I do the back first, keeping the front cool. Then I flip it and finish the bead work on the front side, keeping the back cool. It also keeps solder that runs through from spreading out too much because the coolness helps keep the solder from running through too freely on the other side.

@ellagregory818 10 ай бұрын

Are you learning also ? Is the other guy teaching you ? Just curious. I really liked his foiling instructions

@Mr.StainedGlass 10 ай бұрын

Carlos is showing me several of the basics, unfortunately the fan and fume extractor ruined the audio so I was trying to convey all the lessons with the voice over.