STEMCO Tech Talk on Wheel End Bearing Adjustment September 24th 2020

Рет қаралды 41,040

3 жыл бұрын

STEMCO's Randy Puls, Field Support Manager, shares proper maintenance practices on Wheel End Bearing Adjustment. In this video, he covers proper product identification, tear down, inspection, and reassembly.

Пікірлер: 26

@user-ci3mv3nt8b Ай бұрын

Very informative video! Thanks you sir

@jeremykamel9655 2 жыл бұрын

Are you guys doing any in-person wheel end classes again? P&B Intermodal in Tacoma needs you.

@shepherdsfleetservicesllc8147 Жыл бұрын

We will be using your guys products.

@glackaglack1534 3 жыл бұрын

I really appreciated these videos.

@josenava1498 Жыл бұрын

Hi this is Jose Nava from Sonoma California, work for Recology in Petaluma California, and we have Problems with the Double nuts with the Spacer. I want to know the TORQUE SPECIFICATIONS on TORQUE and setting those bearings.

@falcon8553 3 жыл бұрын

Awesome videos

@the2120company 2 жыл бұрын

"righ off" very precise

@saidbenzekri8426 Жыл бұрын

Thank you , very professional .

@noexcuses6727 3 жыл бұрын

Thank You

@gschmidt7763 Жыл бұрын

Very informative.

@robertleybautista476 2 жыл бұрын

Thanks for this video's sir

@andrzejfloryn5580 3 жыл бұрын

Good

@aristidesgalvez7939 9 ай бұрын

Deseo ver un ajuste de rodamiento en el eje steering ..con trae un espaciador,

@rivera75nesto Жыл бұрын

What’s that part number on that wishbone to hold semi grease?

@trewright1482 Жыл бұрын

102-5015 is the Grease Template Part Number

@envisionCamusa Жыл бұрын

How do I get a certificate?

@paulhanna8820 9 ай бұрын

If the red plug popped out of the stemco cap and it was missing what should be some of the reason to cause it

@niles.a2917 7 ай бұрын

Likely a plugged vent hole inside the red plug. Carefully inspect your components as the heat generated to cause that much pressure to build up is likely a sign of failure.

@dustinmason4678 2 жыл бұрын

Is this for drive axles?

@trewright1482 Жыл бұрын

STEMCO makes Seals for Drive, Steer and Trailer Axles. This procedure works for all axles

@zues2013 6 ай бұрын

Same procedure but how much you back off the nut varies from trailer to drive axels on tractors refer to stemco website for all procedures

@charlesroer972 Жыл бұрын

I’m surprised at how many are supposed to be competent at wheel bearing assembly. For some reason fail . I see a lot of bearings with excessive clearance at the spindle . As this is a slip fit,, not a wobble fit or press fit . Just measure then put new bearings on .or new spindle or axel . I’ve seen over 1/8th inch . Clearance. This is US standard measurement. No metrics here ,, I can but won’t use metrics .