Bryan Perigo, Strategic Accounts Manager, shares features, benefits, and installation instructions on our STEMCO Wheel End components in our efforts of Making The Roadways Safer.
Пікірлер: 6
@stevenlangdon-griffiths293 Жыл бұрын
Good video, very well explained on correct seal fitting.
@jeremycole6450 Жыл бұрын
Do you think it’s easier to install the seal on the spindle rather than on the hub assembly? Or is it just preference
@keithfally41647 ай бұрын
This is just your personal preference.
@saidbenzekri8426 Жыл бұрын
your stemco coworker tech say before if the ware in the spindle is more than 8 thousands of an ich it has to be change and you say between 6 and 10 thousands of an inch , which one is correct ?
@keithfally41647 ай бұрын
A spindle that has wear on the bottom in excess of .008" should be replaced as the wear changes the center line of the hub and will lead to wheel seals failing prematurely.
@cbmech2563 Жыл бұрын
Sorry, as a trash truck mechanic I've replaced hundreds of leaking seals and 95% of those have been stemco or CR. 4% have been a mix of Mechanix brand and other off brands. Probably 1% have been national 37 series and 1 38 series and most if not all were obvious improper bearing adjustment.