Step-by-step Digital Power Supply Design using STM32

No video

Step-by-step Digital Power Supply Design using STM32

Рет қаралды 24,460

3 жыл бұрын

Starting from basics, Dr Ali Shirsavar from Biricha Digital takes you through the Digital PSU design process, explaining how to calculate the control loop coefficients and how to ensure stable operation. Having covered the fundamentals, Ali will then design a power supply from scratch using the free ST-WDS design tool. Finally Dr Michael Hallworth will present the experimental results. Download ST WDS now from: www.biricha.co...

Пікірлер: 9

@johnconrad5487 2 жыл бұрын

The results of the design are phenomenal. Thanks

@hichamlhachimi9594 3 жыл бұрын

Dear Dr.Ali - Sorry I am going to ask a question about a video of yours concerning thevdesign of PI filter in EMI filter design. In fact, you said that the design is a little bit complexe and you have just set three rules for the calculation of the PI cap. I would like to know if you have the full demonstration of those rules, I would really appreciate your help and thank you in advance.

@keerthypr3649 3 жыл бұрын

Hello sir.. i would like to clarify some points regarding NB and WB emission measurements..

@bsodmike 3 жыл бұрын

Dear Dr. Ali - thank you for demonstrating the use of the WDS software. Having watched the STM demo by Dr. Hallworth, could I kindly request that the materials used (code example) be shared with us as well? I would very much like to try implementing this demo SMPS myself in my homelab. Thank you so much!

@bsodmike 3 жыл бұрын

Sorry, I wanted to clarify how we can get access to your 3p3z control library for STM32? I could not find any details on your site, thanks!

@BirichaLectures 3 жыл бұрын

@@bsodmike thanks for your comment - you can download the example software to run on the STM32 Discovery Kit from our website: www.biricha.com/st-discovery-kit

@bsodmike 3 жыл бұрын

Biricha thank you I will give this a try!

@bsodmike 3 жыл бұрын

Biricha also. It might be worth considering a longer video on the extra steps you would deal with to take an SMPS design to production. The whole “this is what you can churn out in 5mins” is great as an intro but I’m keen on something a bit deeper than that. Thanks!