@willierebuildz9182 3 ай бұрын
Sometimes the front and rear take the 447 so check the caps before you press them in nice work you just saved about $500
@87SSBOI 3 ай бұрын
Yessir!! Appreciate ya 🫡…I will be sure to check first…from the looks of it, it’s gonna be the same setup as u did but ima def take my time do it right the first time
@t.l.robinson2162 3 ай бұрын
Using a press to remove the universal joint it is very possible to bend the end of the driveshaft. It is better to use a propane or Mapp torch to melt the plastic and easily remove the u-joint.
@87SSBOI 3 ай бұрын
Yea I had to use a torch
@tredog86 2 ай бұрын
Heat em up til that plastic start coming out. I’ve been there before. Bout ready to be back in the streets 🫡💯💪🏾
@87SSBOI 2 ай бұрын
Yea man I didn’t know but I found out that day…the hard way too 😂
@zacharywallace2243 2 ай бұрын
Really dont..but u can
@Mrc-vy7cn 2 ай бұрын
I need to find one for my obs truck
@dalazdayz 2 ай бұрын
You should have bought a 200-4r you could kept your drive shaft without no modification
@superchargedtrill221 2 ай бұрын
I have a cutlass with a Chevy setup and I have a 700r4 I just found out that I need a 🔒 up controller so you might want to look into it
@87SSBOI 2 ай бұрын
Yea I talked to my trans guy about it
@superchargedtrill221 2 ай бұрын
@@87SSBOI ok and did he tell you to get the kit or it’s a way around it
@zacharywallace2243 2 ай бұрын
If had a long tail 350th u could have used your old drive shaft.
@87SSBOI 2 ай бұрын
Facts
@jemelmonger 3 ай бұрын
Same drive shaft as mine, but I pulled from 2002 Tahoe and modified
@87SSBOI 3 ай бұрын
Nice!!! I didn’t know that’s what u had👌🏾
@jemelmonger 3 ай бұрын
I grabbed a 10mm when I did mine too, the new bolts I put on were 8mm i think for the drive shaft.
@87SSBOI 3 ай бұрын
I’m putting the OG 10mm back in
@FUNCHITUP 3 ай бұрын
You have to change the yolk to the 700r4 one and also change the u joints
@pmotorsports8276 3 ай бұрын
TH350 and 700R4 use the same yoke
@dslyfe 3 ай бұрын
Good vid bro!! Almost back on the road!!
@87SSBOI 3 ай бұрын
Yessir 👌🏾
@Joe-vy6nb 3 ай бұрын
Where is the name of the junkyard and where is it located? I may need that bed from that C10
@87SSBOI 3 ай бұрын
Pick n Pull in Va Beach and there’s another one at Foss U Pull It in Chesapeake
@shuntubbs2682 3 ай бұрын
I was rolling when you was taking the drive shaft out lol. Looking like a soldier going to war lol 😂. Low crawl lol. I seen the blue c10 you might wanna check it out before it’s gone lol
@87SSBOI 3 ай бұрын
😂😂😂
@killapop8471 3 ай бұрын
🔥 Had cutlass wit 700r4 use be fastest I hood lol But like overdrive over 3psd
@87SSBOI 3 ай бұрын
Yessir!!! I gotta have it ✊🏾
@marcosponce4422 3 ай бұрын
Man I feel that pain on not finding them 2wd blazers. I been looking for a while now and I'm still waiting lol found some but gotta drive 2 Nad a half hours away. Or I just bite the bullet and buy off ebay smh.
@87SSBOI 3 ай бұрын
Yes man wish I had been thinking when I got mine and grabbed more…there were like 8 2wd blazers out there last time I went👀👀👀
@marcosponce4422 3 ай бұрын
Yeah grab um all lol. There like hot cakes!
@JohnBlaze-ff3lm 3 ай бұрын
😎😎😎
@87SSBOI 3 ай бұрын
🫡
Camden Bowen
Рет қаралды 1,3 МЛН