You have good patience. I take off the fuel tank because I just need the extra room. Working in tiny places just losses me off. I still get kissed off with the tank removed, just a little less though :). Thanks again.

Good video. But if I may interject here, it’s a little easier to remove the carb from the other side because the intake is angled that way.

I just rebuilt mine with a rebuild kit and a lot of carb cleaner. It wasn't using the main jet when I put it back on and I had to take it off again. I can say that it can come out from both sides. And make sure the needle in the slide is not flopping up and down. That was making it lean for some reason?

Thank you for putting this vid together! I am going to try this with my eiger. Ok a side note, can you tell me what the hose that lies along side the fuel air box is for? I just bought the machine and can't figure it out.

I dont know if you will see this but if so, on the left side of the carb there is a black thing that a hose could hook up to. Do you know where that goes?

The new carb has black plastic where you connect the choke. How did you connect?

Nice Video! On the aftermarket carb did You have to adjust the air/fuel screw if so what was it? Thanks

Are you using the original petcock

How much should I expect to pay for a carb replacement

Do you still recommend the zoom carburetor for the river, I need a new one for my eiger and don't have 400 dollars for OEM One?

What hose goes on the front top of the carburetor that’s going into the motor?

That rubber like you popped off at 6:49 where does that go to?

Any chance you remember how many turns you have the pilot screw set to? Like a dumbass i messed with mine and now i cant get it set right.