Suzuki JR50 Piston Ring replacing

No video

Suzuki JR50 Piston Ring replacing

Рет қаралды 41,036

Күн бұрын

This is an easy job. In fact it applies to most small 2 stroke engines. It shouldn't take an hour. If you have a power valve on your 2 stroke engine, take some pictures to help you replace the little pieces. and you should replace clips holding the power valve metal rod.to the crankshaft

Пікірлер: 14

@MikesHouseWash 2 жыл бұрын

Novice mechanic here. Working on a jr50 I bought my son. Will roll start, and drive. Will kick start. But if you kick it and put it in gear it immediately kills it. Like metal on metal or something. Any clues or advice?

@TheHypnotstCollector 2 жыл бұрын

Not really but I would look at the clutch system, sounds like something is locked up that should slip. And look at more JR50 videos, youtube is great that way....

@joseluissaavedra4364 2 ай бұрын

What's the compression after new rings?

@awoods5318 Жыл бұрын

I have a jr 50 for my son, bought a rebuild kit and the piston ring seen too tight for the groves in the piston

@TheHypnotstCollector Жыл бұрын

Not sure what the ring gap is for a jr50 but it should move up and down! try a feeler gauge, I would Guess around 002-003

@joshuagrimes1905 2 ай бұрын

Do I have to break the glaze if it's a new cylinder

@TheHypnotstCollector 2 ай бұрын

IF it's new it should be ready to use.

@logandeleon5808 4 жыл бұрын

My kickstart won’t move the piston what should I do?

@TheHypnotstCollector 4 жыл бұрын

well, make sure it's in neutral..... If it wont kick over in neutral then you gotta get into the engine. You don't strike me as the type that does engine work

@logandeleon5808 4 жыл бұрын

TheHypnotstCollector okay. Thanks for replying on a 6 year old video and I guess I gotta go into the engine🤦🏼‍♂️

@mountainmatters6402 Жыл бұрын

I cant get the piston to go into the cylinder. Any tips or tricks?

@TheHypnotstCollector Жыл бұрын

make sure it fits without the piston ring on. install the ring buy itself and check the ring gap. Not sure what it should be but 004 should be ok. make sure the ends of the ring are on both sides of the little pin in the piston ring gap that keeps the ring from rotating in the bore