The product works as advertised! but there are some omissions from the video. My kit arrived with the new brackets in a bag and qty-2 missing 4mm bolts. The video needs an edit to the voiceover to say "install the brackets with the hardware provided" etc. Also need to explicitly call out installing the provided pegs into bottom of airbox. Third: if you torque the clamps in the order shown, the airtbox ends up 15-20mm too far right. Works better to leave all clamps loose until after securing airbox to frame with push clip. Then adjust & tighten all hose clamps.

Excellent install video!! I wouldn't expect any less from SXTH ELEMENT

Awesome!!! Can't wait for my replacement PCV hose. Thanks for all the communication through development!

Interesting now need to figure how yo set this up with my radium catch can

Do you car throwing cel when you install aftermarket air intake systems

So what’s going on with the Elantra n-line one I haven’t placed an order yet because the date for pre order receive dates just keep getting pushed back are they made by order or ?

Is the vacuum sensor on the airbox now left with two open ports? The video says to reconnect the electric but does not provide any direction for the two uncovered vacuum ports?

Is the vacuum sensor mounted to the air box supposed to be capped? Other aftermarket intakes remove it completely but I'm assuming that would cause a check engine light

Just about sold on this. Hope the PCV code is fixed. Gonna wait a little.

Is it still on backorder?

Make a dyno video! Is it actually 10+ whp??

I don’t get it. You remove a BOX, replace it by a BOX! Only to install some fishy aftermarket filter? 😵‍💫